Spray lubricant CX80 CX-237 for plastics and rubber, NSF H1, 500 ml

CX80 CX-237 spray lubricant is a 500 ml aerosol designed specifically for plastics and rubber. Classified NSF H1, the formulation is intended for incidental food-contact environments where a thin, non- food-grade lubricating film is required. The product is delivered in an easy-to-use spray can for controlled application to hinges, seals, gaskets and moving parts made from synthetic materials and elastomers, helping reduce friction and sticking without compromising the substrate.

Advantages

The lubricant forms a thin, long-lasting film that reduces wear and friction on plastic and rubber components. Its NSF H1 classification means it is suitable for use in areas with potential incidental food contact. The aerosol format enables precise, low-residue application even in confined or hard-to-reach areas. The formulation is compatible with many synthetic polymers and elastomers and resists wash-off and evaporation better than plain oils.

Suitable for

• Hinges and pivot points with plastic or rubber parts
• Seals, gaskets and O-rings in processing equipment
• Conveyor guides and plastic rollers
• Door and lid closures in food handling areas (incidental contact)
• Maintenance of small moving components made of synthetic materials

Key specifications

• Form: aerosol spray, 500 ml container
• Intended substrates: plastics and rubber (elastomers)
• Food-safety classification: NSF H1 (suitable for incidental food contact)
• Function: lubrication, protection against sticking and friction reduction
• Application: targeted spray for hinges, seals, gaskets and moving parts

How to use

Shake the can well before use and test on a small inconspicuous area to confirm material compatibility. Hold the aerosol 15–25 cm from the target surface and apply a light, even coat. For tight joints or deep crevices use a short burst of spray or a straw attachment if available. Allow the film to settle for a short time before operating the mechanism. Reapply as needed based on wear or operating conditions.

Usage recommendations

Avoid applying to heavily loaded metal-to-metal bearings where a specialised high-pressure grease is required. Use in well-ventilated areas and avoid direct contact with food surfaces; if direct contact occurs, clean the food-contact surface according to established hygiene procedures. Store the product upright, away from heat sources and open flame.