Hole saw Dedra 08W064 — diameter 64 mm, for metal, stainless steel, aluminium, plastic, wood

Dedra 08W064 is a single-piece hole saw with a 64 mm cutting diameter designed for drilling round openings in a variety of materials. Manufactured for tasks where a precise circular hole is required, this hole saw is suitable for use with standard arbor attachments and fits common drill setups used in workshops and on construction sites. It is intended for creating passages for pipes, cable entries, fittings and other installation points in metal, stainless steel, aluminium, plastic and wood.

Advantages

The one-piece construction provides stable cutting performance and reduces the risk of blade detachment during use. With a 64 mm diameter it covers common installation needs while remaining compact enough for handheld drilling. The tooth geometry and material choice are balanced for cutting across ferrous and non-ferrous metals as well as plastics and wood, delivering consistent hole quality. Compatibility with standard arbors makes mounting and replacement simple for both workshop and field work.

Suitable for

• Making holes for pipe and conduit installations
• Creating cable and wiring passages in panels and walls
• Cutting openings for fittings, flanges and switches
• General workshop drilling in metal, aluminium, plastic and wood

Key specifications

• Cutting diameter: 64 mm
• Design: single-piece hole saw
• Suitable materials: steel, stainless steel, aluminium, plastic, wood
• Mounting: compatible with standard arbor attachments
• Typical use: manual drills and drill presses in workshop and construction settings

How to use

Secure the hole saw onto a compatible arbor according to the arbor manufacturer's instructions and tighten the fixing screw or nut. Mark the centre point of the hole, clamp the workpiece if possible, and use a pilot drill or centre punch to prevent walking. Start drilling at low speed to establish the cut, then increase speed as appropriate for the material while applying steady, even pressure. For metal and stainless steel, use cutting lubricant to reduce heat and extend tool life. After cutting, remove burrs and clean the hole as needed.

Usage recommendations

For best performance in metal and stainless steel, use appropriate cutting fluid and moderate feed pressure; for plastics and wood, use higher speeds and lower pressure to avoid melting or splintering. Check arbor compatibility before use and replace worn hole saws to maintain hole quality and safety.