Hole saw Dedra TCT 54 mm (5/8") for wood and soft materials, model 08X054

Dedra TCT hole saw 54 mm (5/8") model 08X054 is a circular cutting tool with a tungsten carbide-tipped (TCT) tooth geometry developed for making clean, accurate holes in wood and other soft materials. The saw body and cutting edge are shaped to produce smooth openings for installations such as pipes, cable pass-throughs and door hardware. The tool is designed to be mounted on compatible arbors with a 5/8" mount and driven by a hand drill or drilling machine.

Advantages

The TCT cutting edge provides enhanced wear resistance compared with standard high-speed steel teeth, maintaining sharpness over longer runs and delivering consistent cutting performance. Its 54 mm diameter produces precise, repeatable holes with minimal splintering when used with appropriate drilling speeds and pilot bits. The hole saw’s geometry and material selection reduce the frequency of re-sharpening and replacement, supporting efficient on-site work.

Suitable for

• Cutting circular openings in softwoods and hardwoods
• Creating holes for pipes, cables and conduits
• Installing door hardware, locks and fittings
• General woodworking tasks requiring clean, repeatable holes

Key specifications

• Nominal diameter: 54 mm (5/8")
• Cutting material: tungsten carbide-tipped (TCT) teeth
• Intended materials: wood and other soft materials
• Mount type: compatible with 5/8" arbors
• Typical application: use with hand drills and drilling machines

How to use

Secure the appropriate arbor with a pilot bit compatible with the 5/8" mount, clamp the workpiece if possible to prevent movement, and mark the center of the hole. Start drilling at low speed to engage the pilot and then increase speed to the recommended range for the material being cut. Apply steady, moderate pressure and allow the saw to cut without forcing; withdraw periodically to clear chips for cleaner results. After cutting, inspect the hole edge and remove any remaining splinters with suitable sanding or trimming tools.

Usage recommendations

Use pilot drilling and appropriate feed speed for the specific wood type to minimize splintering. For cleaner results on laminated or veneered surfaces, consider backing the workpiece with sacrificial material. Wear eye and hand protection and follow the drill and arbor manufacturer’s safety instructions.