Angle clamp Dedra 65x70 mm model 12A002

Angle clamp Dedra 65x70 mm model 12A002 is a right-angle fastening tool designed to hold two workpieces at a fixed 90° position during assembly, gluing or drilling. The clamp features jaws sized 65 x 70 mm that provide contact over a moderate surface area to stabilise wood, metal or composite parts while you align, fasten or bond them. Its compact form factor makes it suitable for workshop benches and limited-space setups where reliable right-angle positioning is needed.

Advantages

The clamp offers firm, repeatable 90° alignment and steady holding force for a variety of materials. Its jaw dimensions allow good surface contact without excessive bulk, and the construction is tailored for frequent placement and removal during assembly tasks. The tool simplifies accurate positioning during adhesive cures, screw or rivet installation, and its compact size supports portability between job sites and workstations.

Suitable for

• Woodworking joints and cabinet assembly
• Metal frame tack-welding and fixture holding
• Gluing and bonding operations that require exact right angles
• DIY projects and small repairs needing precise alignment

Key specifications

• Jaw contact dimensions: 65 x 70 mm for stable bearing surface
• Fixed 90° clamping angle for accurate right-angle assembly
• Compact footprint suitable for bench and portable use
• Material compatibility: suitable for wood, metal and composite parts

How to use

Position the two workpieces against the clamp's 90° shoulders so that each piece rests fully on a jaw surface. Tighten the clamp until the parts are held firmly without crushing the material; ensure even contact along the jaw faces to maintain true alignment. While the clamp holds the pieces, proceed with gluing, drilling, fastening or welding as required. Release the clamp after the adhesive cures or fasteners are set.

Usage recommendations

For best results, protect delicate surfaces with thin pads before clamping, and verify squareness with a try-square after tightening. Avoid over-tightening on soft materials to prevent deformation, and allow adhesive joints to reach recommended cure times while clamped.