Clamping Bar / Workbench Clamp Dedra F 1000x120 mm with 2-material Handle

Dedra F 1000x120 mm workbench clamp is a bar clamp designed for woodworking and general clamping tasks. It provides a 1000 mm clamping span and a 120 mm throat depth, enabling secure holding of panels, frames and assemblies during gluing, sawing and drilling. The clamp is equipped with a two-material ergonomic handle that improves grip and control while tightening and releasing the clamp, and a durable bar and jaw construction suited for repeated workshop use.

Advantages

The two-material handle combines a firm core with a softer outer layer to reduce hand fatigue and improve torque transfer. The long 1000 mm bar allows clamping of larger workpieces and assemblies without the need for multiple clamps. A 120 mm throat depth gives access farther from the edge, useful for clamping centers and inner sections. The clamp’s simple sliding jaw mechanism enables fast position adjustments and reliable pressure distribution across the jaws.

Suitable for

• Woodworking gluing and assembly of panels and frames
• Securing workpieces for sawing and routing
• Holding parts during drilling and fastening
• Temporary fixtures in carpentry and DIY projects

Key specifications

• Clamping length: 1000 mm
• Throat depth: 120 mm
• Handle: two-material ergonomic design for improved grip
• Bar type: fixed long bar with sliding jaw
• Application: manual bar clamp for woodworking and general workshop use

How to use

Position the fixed jaw against one side of the workpiece and slide the movable jaw along the bar until it reaches near the opposite side. Use the ergonomic two-material handle to tighten the clamp by turning or actuating the tightening mechanism until the workpiece is held firmly but without over-compressing glue lines or delicate materials. To adjust clamp position, release slightly, slide the jaw, and re-tighten. After completing the operation, fully release the clamp and remove the workpiece.

Usage recommendations

For even pressure distribution and to protect finished surfaces, use protective pads between the clamp jaws and the workpiece. Avoid excessive force when tightening to prevent deformation of thin materials. Store the clamp in a dry place and periodically inspect the bar and jaws for wear or damage to ensure consistent clamping performance.