Hole Saw DEDRA DED1584S30 3 cm for Stone and Ceramic

The DEDRA DED1584S30 3 cm hole saw for stone and ceramic is a compact cutting accessory designed for precise circular drilling in hard masonry materials. Made for use with compatible drill drivers and drill rigs, this hole saw features a 30 mm diameter suited to tasks such as pipe penetrations, tile openings and small conduit or fixture installation. The tool is intended to deliver clean, consistent holes in natural stone, ceramic tiles and similar surfaces when used with appropriate drilling technique and equipment.

Advantages

This hole saw combines a compact 30 mm cutting diameter with a tooth geometry and material selection optimized for stone and ceramic. Its construction provides durability under intermittent use and helps maintain edge sharpness for multiple cuts. The size and design support accurate alignment and controlled cutting, reducing the risk of chipping on tiled surfaces when operated at recommended speeds and with proper support.

Suitable for

• Drilling openings in ceramic wall and floor tiles
• Creating neat holes in natural stone and masonry
• Making passages for small pipes, cables or fixtures through tiled surfaces
• Repair and renovation tasks where precise 30 mm holes are required

Key specifications

• Cutting diameter: 30 mm
• Intended materials: stone and ceramic
• Suitable tool type: drill drivers and drill rigs with compatible arbor
• Design: circular hole saw for precise, small-diameter holes

How to use

Fit the hole saw to a compatible arbor or mandrel and secure it in the drill chuck according to the drill manufacturer's instructions. Mark the drilling position on the material and ensure the workpiece is supported to prevent movement. Start drilling at low speed to establish the cut, apply steady axial pressure and increase speed as appropriate for the material and tool. For ceramic and stone, use water or coolant as applicable to reduce heat and extend the tool life; pause periodically to clear debris and check progress. After cutting, remove the core and smooth any rough edges as needed.

Usage recommendations

Use protective eyewear and gloves, clamp or support tiles and stone to prevent cracking, and select drill speeds and coolant methods suitable for hard brittle materials. Replace the hole saw if cutting performance degrades to avoid damaging the workpiece.