Staples for plastic RS38 0.8 mm V-angle for corners 100 pcs — Dedra

Pack of 100 Dedra RS38 staples designed for fastening plastic materials at corners and edges. Each staple features a 0.8 mm wire diameter and a V-angle profile that provides precise penetration and secure hold in thin plastic trims, corner profiles and flexible mouldings. These staples are intended for use with RS38-type staplers and are sized for applications that require a narrow, angled staple to fasten corners without splitting or deforming the material.

Advantages

The V-angle design concentrates force at the point of entry to reduce material stress and improve holding power on thin or flexible plastics. A 0.8 mm wire diameter balances strength and minimal surface disruption, allowing reliable fixation while avoiding excessive splitting or cracking. Packaged in a count of 100, the staples are convenient for small repair jobs, installation of plastic trims and repetitive corner fastening tasks where consistent staple shape and size matter.

Suitable for

• Securing plastic corner profiles and edging
• Fastening thin plastic trims and mouldings
• Repairing small plastic housings and panels
• Trim and assembly work requiring angled staples

Key specifications

• Wire diameter: 0.8 mm
• Staple shape: V-angle for corners
• Quantity: 100 pieces per pack
• Compatible stapler type: RS38-series staplers

How to use

Install the staples in an RS38-compatible stapler following the tool manufacturer’s loading instructions. Position the plastic pieces or trim so the corner or edge is supported and aligned. Apply firm, even pressure when driving the staple to ensure the V-angle penetrates fully without bending the strip. For best results, drive staples at a right angle to the work surface and avoid overdriving which can deform thin plastic. If necessary, test on a scrap piece of the same material to set the correct stapling force.

Usage recommendations

Use 0.8 mm V-angle staples for delicate plastic trims where a narrow, angled staple reduces splitting. When fastening brittle or very thin plastics, pre-support the area or use a backing piece to prevent cracking. Store packs in a dry place to keep staples free of corrosion and ensure consistent performance.