Staples for plastic, Dedra RS18 type, 0.8 mm wire, small crown, 100 pcs

Pack of 100 Dedra RS18 type staples designed for fastening plastic materials. Each staple is formed from 0.8 mm wire and features a small crown profile that provides secure, low-profile fastening for thin plastic sheets, trims, and lightweight assemblies. These staples are compatible with staplers that accept RS18-type narrow crown staples and are intended for light to medium-duty joining tasks where a neat finish and minimal material distortion are required.

Advantages

Staples for plastic Dedra RS18 type combine consistent wire thickness and a small crown to deliver reliable holding power without excessive penetration. The 0.8 mm wire provides a balance between strength and reduced material splitting, while the small crown helps conceal the fastener and maintain a low profile. Supplied in a compact pack of 100 pieces, they are convenient for periodic maintenance, upholstery trims, and small assembly projects.

Suitable for

• Fastening thin plastic sheets and trim to frames or substrates
• Upholstery and interior trims where narrow crown staples are preferred
• Light assembly tasks and fixtures involving plastic components
• Temporary or permanent joins where minimal surface damage is important

Key specifications

• Wire thickness: 0.8 mm
• Crown type: small / narrow crown
• Pack quantity: 100 pieces
• Intended use: fastening plastic materials, trims, and lightweight assemblies

How to use

Use these Dedra RS18 type staples with a compatible RS18 narrow crown stapler. Position the plastic component against the substrate, align the stapler over the intended fastening point, and apply firm, steady pressure or trigger the stapler according to the tool's operation method. Ensure the stapler is loaded with the correct staple size and that the contact surface is supported to avoid bending the staple legs. For a cleaner finish, countersink slightly if the material and tool allow.

Usage recommendations

For best results, test a staple on a spare piece of the same plastic to confirm holding strength and appearance before proceeding. Avoid using these staples on very brittle or extremely thick plastics; choose a thicker wire or different fastening method if greater shear strength is required.