Angle grinder accessory Dedra DED7749C4 — 22.5 cm diameter, 1 piece

Dedra DED7749C4 is a single-piece angle grinder accessory with a 22.5 cm diameter designed for mounting on compatible angle grinders. Supplied as one unit, this accessory is intended for general cutting, grinding and surface-preparation tasks depending on the specific attachment type used with the grinder. The accessory fits applications that require a 22.5 cm disc size and is suitable for both DIY and professional environments where this diameter is needed.

Advantages

This 22.5 cm accessory provides a balance between cutting area and maneuverability for medium-scale tasks. Being a single, ready-to-mount unit simplifies replacement and inventory management. Its standardized diameter ensures compatibility with grinders designed for 22.5 cm discs, enabling predictable performance when used with suitable tools and attachments.

Suitable for

• Cutting metal, pipe and sheet materials when paired with an appropriate cutting disc
• Grinding and smoothing surfaces using grinding wheels or flap discs of matching diameter
• Surface preparation such as rust removal and paint stripping with wire or abrasive attachments
• Workshop, construction sites and garage tasks requiring a 22.5 cm accessory

Key specifications

• Diameter: 22.5 cm
• Quantity in package: 1 piece
• Intended use: angle grinder accessory for cutting, grinding, surface preparation
• Compatibility: designed for angle grinders that accept 22.5 cm accessories
• Suitability: for both DIY and professional use

How to use

Ensure the angle grinder is powered off and unplugged or the battery is removed before fitting the accessory. Mount the accessory according to the grinder manufacturer’s instructions, securing it with the correct flange and nut for 22.5 cm discs or attachments. Verify that the accessory type (cutting disc, grinding wheel, flap disc, wire wheel, etc.) is suitable for the intended material and that its maximum operating speed matches or exceeds the grinder’s no-load speed. After mounting, wear appropriate personal protective equipment and perform a short trial run at operating speed to check for wobble or improper mounting before starting work.

Usage recommendations

Use the accessory only with angle grinders that explicitly support a 22.5 cm diameter. Match the accessory type to the task—cutting discs for cutting, grinding wheels for material removal, and wire or abrasive attachments for surface preparation. Regularly inspect the accessory for wear, cracks or damage and replace it immediately if defects are found. Follow safety guidelines including eye, ear and hand protection, and avoid exceeding the rated speed of the accessory.