Grinding/Cutting Disc for Angle Grinder Dedra H1065E, Ø 200 mm, 1 pc

Replacement grinding/cutting disc for angle grinder compatible with Dedra H1065E. This 200 mm diameter disc is supplied as a single piece and is designed to perform cutting and grinding operations when matched to the correct disc type and the machine's rated speed. The disc is intended for use on an angle grinder for tasks such as trimming, shaping, or separating materials in metalworking, masonry, and general construction when the correct abrasive or cutting specification is selected.

Advantages

The disc offers a standard 200 mm size that fits many common angle grinders and provides a balance between cutting depth and control. Supplied as a single unit, it is easy to replace on the machine spindle. When the appropriate material-specific variant is used, the disc provides consistent abrasive performance and predictable wear characteristics suitable for routine workshop and site tasks.

Suitable for

• Cutting metal sheets and profiles when using a metal cutting variant
• Grinding and shaping welds or edges with an abrasive grinding variant
• Cutting or trimming masonry and concrete when an appropriate masonry disc is used
• General fabrication and maintenance tasks on construction sites and in workshops

Key specifications

• Diameter: 200 mm
• Quantity: 1 piece
• Compatibility: designed for use with angle grinders matching 200 mm discs
• Intended operations: cutting and/or grinding depending on the disc material and grit
• Mounting: standard centre hole for angle grinder spindle (ensure correct flange and nut fit)

How to use

Before fitting the disc, disconnect the angle grinder from the power source. Inspect the disc for visible damage or cracks; do not use a damaged disc. Fit the disc onto the grinder spindle using the correct flange and tightening nut, ensuring it is secure but not over-tightened. Set the grinder to the recommended speed for the disc type and material. During operation, hold the grinder firmly with both hands, maintain a stable stance, and apply consistent, moderate pressure. Allow the disc to reach full speed before contacting the workpiece and avoid lateral twisting or forced bending of the disc.

Usage recommendations

Use the disc variant that matches the material being worked on (metal, masonry, or general grinding). Always observe the angle grinder manufacturer's maximum RPM rating and wear appropriate personal protective equipment such as eye protection, gloves, and hearing protection. Replace the disc when wear reduces cutting efficiency or if any structural damage is detected.