Angle grinder accessory Dedra H10GM13 — 100 mm cutting/grinding disc adapter, M14 thread, 1 pc

Dedra H10GM13 is an angle grinder accessory designed to adapt 100 mm cutting and grinding discs to grinders with an M14 spindle thread. Supplied as a single unit, the adapter enables secure mounting of compatible 100 mm discs and wheels, allowing use of smaller-diameter consumables for metal and masonry cutting, grinding and surface preparation. The adapter is intended for installation on angle grinders equipped with an M14 threaded arbor and is suitable for common workshop and site tasks where a 100 mm disc is preferred for precision or access in confined areas.

Advantages

The adapter provides a straightforward mechanical interface that holds 100 mm discs firmly in place on M14-threaded spindles. Its compact design reduces overhang and improves control when working in tight spaces compared with larger accessories. By enabling use of 100 mm consumables, the adapter can lower material costs and broaden the range of tasks a single grinder can perform without requiring alternative machines or special flanges.

Suitable for

• Cutting metal pipes, rods and profiles with 100 mm discs
• Grinding and deburring small welded joints and seams
• Masonry cutting and trimming in confined or detailed areas
• Surface preparation and light material removal on steel and concrete

Key specifications

• Compatible disc diameter: 100 mm
• Spindle connection: M14 threaded interface
• Piece count: 1 adapter per pack
• Intended use: mounting of cutting and grinding discs/wheels

How to use

Before installation, ensure the angle grinder is powered off and disconnected from its power source. Remove any existing flange or accessory from the M14 spindle, then thread the adapter onto the spindle by hand until it is seated. Fit the 100 mm disc onto the adapter according to the disc manufacturer’s instructions and secure with the appropriate locking nut or flange provided with the grinder. Tighten to the recommended torque, check that the disc runs true without wobble, and perform a short no-load run to verify correct installation before beginning work.

Usage recommendations

Use only discs rated for the grinder’s maximum speed and follow all safety instructions for personal protective equipment, including eye, hearing and hand protection. Inspect adapter and consumables for damage before each use and replace if worn or deformed. Avoid side-loading discs beyond their intended use and maintain steady, controlled feed to reduce the risk of disc failure.