Angle grinder accessory Dedra H1183 — 35 cm diameter, 1 pc

Dedra H1183 is an angle grinder accessory with a 35 cm diameter supplied as a single unit. It is designed to fit compatible angle grinders and to serve as a replacement or spare part for a variety of tasks depending on the mounted attachment. The accessory is intended for workshop and construction use where a large-diameter disc or mounting platform is required for cutting, grinding or surface preparation operations.

Advantages

The large 35 cm diameter provides extended coverage for faster material removal and wider cuts compared with smaller accessories. Being sold as a single piece makes it simple to keep a spare part on hand for maintenance or rapid replacement. The design is compatible with standard angle grinder attachments, allowing flexibility to adapt the tool to different tasks by fitting appropriate discs, brushes or sanding pads. The accessory is suitable for heavy-duty and frequent use in workshop and construction environments where robust, high-coverage tools are needed.

Suitable for

• Cutting large panels and sheet materials when fitted with appropriate cutting discs
• Grinding broad surfaces with coarse grinding attachments
• Surface preparation such as rust and paint removal when used with wire brushes or sanding pads
• Replacing worn or damaged mounting platforms on compatible angle grinders

Key specifications

• Diameter: 35 cm
• Quantity per pack: 1 piece
• Compatibility: designed for use with compatible angle grinders and standard attachments
• Intended applications: cutting, grinding, surface preparation depending on mounted attachment
• Typical environments: workshop, construction sites

How to use

Select and fit the appropriate attachment for the intended task (cutting disc, grinding wheel, wire brush or sanding pad) onto the accessory following the angle grinder manufacturer’s instructions. Ensure the grinder is powered off and disconnected from the power source before mounting or replacing the accessory. Secure the assembly according to the tool’s fastening system, check for correct alignment, and perform a brief run-up at low speed to confirm stability before normal operation. Observe recommended speed and safety limits of both the angle grinder and the mounted attachment.

Usage recommendations

Use appropriate personal protective equipment including eye protection, hearing protection and gloves. Verify that the selected attachment is rated for the grinder’s speed and is compatible with a 35 cm mounting platform. Inspect the accessory and attachment for damage before each use and replace if any cracks, excessive wear or deformities are found. Store the accessory in a dry place to prevent corrosion and maintain its service life.