Drill bit Dedra WDD10230, diameter 10 mm, length 230 mm, for wood, 1 pc

Dedra WDD10230 is a single 10 mm diameter wood drill bit with a 230 mm overall length, designed for drilling through-holes and deep bores in timber, laminated boards and other similar wooden materials. The bit is supplied as one piece and is intended for use with compatible hand drills or drill drivers. Its length and cutting geometry make it suitable for reaching deeper points while maintaining concentric drilling performance in wood.

Advantages

The Dedra WDD10230 combines a 10 mm cutting diameter with an extended 230 mm length to enable deep and precise wood drilling without the need for extensions. The geometry of the flutes promotes efficient chip evacuation and reduces clogging during long bores. As a single-piece consumable, it is easy to store and replace, and its dimensions are compatible with standard chucks used in hand drills and cordless drivers.

Suitable for

• Drilling through-holes in solid timber
• Creating deep bores in laminated boards and chipboard
• Installation of long dowels or running cable/pipe passages through wooden elements
• General woodworking tasks requiring a 10 mm hole

Key specifications

• Diameter: 10 mm
• Overall length: 230 mm
• Material compatibility: wood, laminated boards, similar wooden materials
• Quantity in pack: 1 piece
• Intended use: through-holes and deep drilling in wood

How to use

Secure the drill bit in a compatible drill chuck or driver and tighten firmly to prevent slipping. Mark the drilling point on the workpiece, clamp the piece to avoid movement, and set the drill to an appropriate speed for wood drilling. Start drilling with light pressure to establish the cut, then apply steady, even force while allowing the flutes to evacuate chips. Withdraw the bit occasionally if chips accumulate to maintain cutting efficiency and prevent overheating.

Usage recommendations

Use appropriate personal protective equipment, including eye protection and hearing protection as needed. For cleaner holes and reduced tear-out, consider backing the workpiece where the bit exits. Match drill speed and feed rate to the wood type: lower speeds for hardwoods and higher speeds for softwoods, and remove accumulated chips during deep drilling.