Drill bit Dedra WIT06093 — 6 mm diameter, 93 mm length, for metal, 1 pc

Dedra WIT06093 is a single 6 mm twist drill bit with a total length of 93 mm, designed specifically for drilling metal. Compatible with standard hand drills and drill presses, this drill bit is intended for creating through-holes, pilot holes and general metalwork tasks on steel and other ferrous and non-ferrous metals. The tool provides straightforward drilling performance suitable for repair, fabrication and everyday workshop use.

Advantages

The 6 mm diameter and 93 mm overall length offer a balance between reach and rigidity for typical metal drilling operations. Its geometry is engineered for consistent chip evacuation and stable cutting on metal surfaces. Supplied as a single piece, the bit is convenient for replacing worn tools or keeping one in a basic repair kit. The design is compatible with common chucks and mounting systems used in hand drills and drill presses.

Suitable for

• Drilling through-holes in steel sheets and metal plates
• Creating pilot holes for screws or bolts in metal workpieces
• General repair and fabrication tasks in workshops and construction sites
• Use with hand drills and drill presses

Key specifications

• Diameter: 6 mm
• Overall length: 93 mm
• Intended material: Metal (steel and other metals)
• Quantity: 1 piece

How to use

Mount the Dedra 6 mm twist drill securely in the drill chuck and ensure the workpiece is clamped or supported to prevent movement. Select an appropriate drill speed for the metal type and thickness—typically a lower speed for harder steels and higher speeds for softer metals. Apply steady, moderate feed pressure and use cutting fluid or lubricant when drilling harder metals to extend bit life and improve cutting performance. Withdraw the bit occasionally to clear chips and avoid overheating.

Usage recommendations

For best results, pre-mark and center-punch the drilling position to avoid wandering. Use suitable cutting fluid on steel and hardened materials, and replace the bit when wear or chipping of the cutting edges is observed. Observe standard safety practices: wear eye protection and secure the workpiece before drilling.