Drill bit Dedra WP0611, 6 mm diameter, 50 mm working length, for concrete/brick/stone/aerated concrete, 1 pc

Dedra WP0611 drill bit, 6 mm diameter with 50 mm working length, is designed for rotary and hammer drilling in masonry materials. The carbide-tipped head and hardened shaft provide wear resistance and maintain cutting performance when used in concrete, brick, natural stone and aerated concrete. Supplied as a single piece, this drill bit is intended for making holes for anchors, dowels and through-holes during construction, repair and renovation tasks.

Advantages

The carbide tip ensures effective cutting and longer service life compared with uncoated bits when drilling masonry. The 6 mm diameter and 50 mm working length balance access into typical wall and slab thicknesses while limiting excess protrusion. The bit is compatible with both rotary and hammer drilling modes, offering versatility for different drill types. A standardized shank profile allows secure clamping in common drill chucks for steady operation.

Suitable for

• Drilling holes for wall anchors and dowels in concrete and brick
• Creating through-holes in natural stone and masonry
• Fixing fixtures and fittings during renovation and installation work
• Drilling into aerated concrete blocks for light-duty anchoring

Key specifications

• Diameter: 6 mm
• Working length: 50 mm
• Tip material: carbide-tipped cutting head
• Intended materials: concrete, brick, natural stone, aerated concrete
• Drilling modes: rotary and hammer drilling suitable
• Quantity: 1 piece

How to use

Install the Dedra WP0611 drill bit into a compatible drill chuck and tighten securely. Select hammer mode for reinforced concrete or rotary-only mode for softer masonry as appropriate. Mark the drilling point, start at low speed to establish a guide, then increase speed and apply steady pressure without forcing the bit. Withdraw periodically to clear dust and prevent overheating. For through-holes, continue until the required depth is reached; for anchor holes, stop at the necessary working depth to match the anchor length.

Usage recommendations

Use appropriate personal protective equipment including safety glasses, gloves and hearing protection. Match drill mode to material: use hammer action for dense concrete and rotary mode for softer brick or aerated concrete. Avoid excessive lateral force to prevent bit breakage; keep the bit cool by clearing debris frequently. Inspect the bit before use and replace if the carbide tip is chipped or worn.