Drill bit Dedra WP0616 — 6 mm diameter, working length 100 mm, for concrete/brick/stone/aerated concrete

Dedra WP0616 masonry drill bit, 6 mm diameter with a 100 mm working length, is designed for drilling in concrete, brick, natural stone and aerated concrete. Supplied as a single piece, this drill bit is compatible with hammer and rotary hammer drills featuring matching chucks and is intended for creating anchor holes, fixing points, through-holes and preparatory openings in masonry and lightweight concrete elements.

Advantages

The solid-design masonry bit provides consistent drilling performance in a range of masonry substrates. Its 6 mm diameter and 100 mm working length allow for precise, deep holes needed for anchors and fasteners while maintaining stability during use. The single-piece supply simplifies selection and replacement, and the bit is suitable for both hammer and rotary hammer tools when the chuck accepts its shank type. The geometry and material treatment are optimized for drilling in abrasive mineral materials, reducing the risk of premature wear and helping to maintain hole accuracy.

Suitable for

• Creating anchor and fixing holes in concrete and brick
• Drilling through natural stone for mounting fixtures
• Preparing openings in aerated concrete for installations
• General-purpose masonry drilling with hammer or rotary hammer drills

Key specifications

• Diameter: 6 mm
• Working length: 100 mm
• Compatible materials: concrete, brick, natural stone, aerated concrete
• Quantity: 1 piece

How to use

Secure the drill in a compatible hammer or rotary hammer drill chuck and select an appropriate drilling mode for masonry. Mark the drilling position, start at low speed to establish the center, then apply steady pressure while drilling at hammer action for dense materials such as concrete or stone. For aerated concrete, use a rotary or lower-impact mode if available to avoid overloading the bit. Withdraw the bit periodically to clear dust and reduce overheating. After drilling, clean the hole of debris before inserting anchors or fasteners.

Usage recommendations

Use personal protective equipment such as safety glasses, dust mask and hearing protection when drilling masonry. Match drill speed and hammer setting to the material: higher hammer action for dense concrete and stone, reduced impact for aerated concrete. Replace the bit if wear reduces drilling efficiency or hole quality.