Drill bit Dedra WP1260 — Ø12 mm, working length 54 mm, for concrete/brick/stone/aerated concrete, 1 pc

Dedra WP1260 drill bit with a 12 mm diameter and 54 mm working length is designed for drilling through masonry and structural materials such as concrete, brick, natural stone and aerated concrete. Supplied as a single piece, this carbide-tipped masonry drill is intended for use with rotary and hammer drilling modes to create precise holes for anchors, dowels and through-fixings in construction and installation tasks.

Advantages

The 12 mm diameter and 54 mm working length provide a balance between reach and rigidity for common fastening and installation needs. The tip geometry and material are engineered for penetration in hard substrates while maintaining hole accuracy. Being a single-piece supply simplifies selection and inventory for specific drill sizes during job preparation.

Suitable for

• Drilling holes for anchors and dowels in concrete and brick
• Creating through-holes in stone and masonry for installations
• Preparing mounting points in aerated concrete and lightweight blocks
• General rotary and hammer drilling tasks on structural materials

Key specifications

• Diameter: 12 mm
• Working length: 54 mm
• Material compatibility: concrete, brick, natural stone, aerated concrete
• Intended drilling modes: rotary and hammer drilling
• Package quantity: 1 piece

How to use

Fit the Dedra WP1260 drill bit into the appropriate drill chuck and secure it firmly. Select rotary or hammer mode depending on the substrate hardness; use hammer mode for concrete and dense brick, and rotary mode for softer stone or aerated concrete if recommended by the drill manufacturer. Position the tip at the marked drilling point, apply steady axial pressure, and drill at a controlled speed to avoid overheating or bit deflection. Clear dust from the hole periodically to maintain drilling efficiency and check hole depth against anchor or dowel requirements.

Usage recommendations

Wear appropriate personal protective equipment, including eye protection and hearing protection. Use correct drill speed and mode for the material; for deep or large-diameter holes consider peck drilling and periodic withdrawal to remove debris. For best anchor and fastening performance, verify hole diameter and depth match the fastener manufacturer's instructions.