Drill bit Dedra WPQ1060, diameter 10 mm, for concrete/brick/stone/aerated concrete, point angle 135° (1 pc)

Single Dedra WPQ1060 masonry drill bit with a 10 mm diameter, designed for drilling into hard building materials such as concrete, brick, stone and aerated concrete. The bit has a 135° point angle that helps with centring and reduces chipping when starting holes in brittle surfaces. Supplied as one piece, this carbide-style masonry drill is intended for hammer and rotary-percussion drilling in construction, renovation and repair tasks.

Advantages

The 10 mm diameter provides a common, versatile hole size for anchors, dowels and through-fixings. A 135° point angle improves initial bite and accuracy on masonry surfaces and minimises surface damage. The single-piece supply allows quick replacement in a drill bit set or tool bag. The bit is compatible with standard rotary-percussion drills and hammer drills for efficient masonry drilling.

Suitable for

• Drilling holes for wall plugs and anchors in concrete and brick
• Installing fixtures in natural stone and masonry
• Preparing openings in aerated concrete blocks
• General construction and renovation tasks requiring a 10 mm masonry hole

Key specifications

• Diameter: 10 mm
• Point angle: 135° for improved centring and reduced chipping
• Material suitability: concrete, brick, natural stone, aerated concrete
• Quantity: 1 piece
• Intended use: rotary-percussion and hammer drilling in masonry

How to use

Secure the drill bit in a compatible drill chuck or SDS adapter as required by your tool. Mark the drilling point and, if possible, start at low speed to establish the centre. Use a hammer or rotary-percussion drilling mode for hard masonry; apply steady pressure without forcing the bit. Clear dust from the hole periodically to maintain drilling efficiency. After use, clean debris from the bit and store it dry to reduce wear.

Usage recommendations

Wear appropriate personal protective equipment such as safety glasses, hearing protection and a dust mask when drilling masonry. Match drill speed and feed pressure to the material: lower speeds and moderate pressure for hard stone or dense concrete, higher speed and intermittent feed for softer brick or aerated concrete. Use the 10 mm diameter for standard anchor sizes and confirm anchor manufacturer recommendations for hole depth and clearance.