Filament for 3D printing Devil Design PETG Turquoise 1 kg 1.75 mm

Devil Design PETG Turquoise filament is a 1 kg spool of 1.75 mm PET-G polymer intended for FDM/FFF 3D printing. Manufactured from Polyethylene Terephthalate Glycol (PETG), this turquoise filament offers a balance of strength, layer adhesion and chemical resistance while remaining straightforward to print on most 3D printers that accept 1.75 mm filament. The filament is wound on a spool and supplied vacuum-packed with a moisture absorber to reduce moisture uptake during storage and transport. It is suitable for producing functional parts, prototypes and visual models where durability and a semi‑gloss translucent appearance are required.

Advantages

PETG combines the toughness and chemical resistance of a polyester with easier printability than some engineering plastics. This turquoise 1.75 mm filament provides reliable interlayer adhesion, reduced warping compared with ABS, and a degree of flexibility that helps avoid brittle failures. The 1 kg spool format gives a standard quantity for medium-sized projects and testing, while vacuum packing with desiccant helps maintain filament condition prior to use. The material is compatible with common FDM/FFF printers and works with a wide range of nozzle temperatures and printing speeds when settings are adjusted appropriately.

Suitable for

• Functional parts and housings that require impact resistance and chemical stability
• Prototypes and engineering models for form and fit testing
• Visual models, fixtures and jigs with a semi‑gloss turquoise finish
• Medium‑size prints made on 1.75 mm direct‑drive or Bowden extruder systems

Key specifications

• Material type: PETG (Polyethylene Terephthalate Glycol)
• Filament diameter: 1.75 mm
• Spool weight: 1 kg net filament
• Color: Turquoise (semi‑gloss/translucent appearance depending on print settings)
• Packaging: Vacuum sealed with moisture absorber

How to use

Load the 1.75 mm filament into any FDM/FFF printer that accepts 1.75 mm material. Before printing, condition the filament by removing it from vacuum packaging and allowing it to reach room temperature; if the filament has absorbed moisture, consider drying according to your printer manufacturer’s or filament supplier’s recommendations. Typical print settings for PETG are a nozzle temperature range around 230–250°C and a heated bed temperature around 60–80°C, but exact values depend on your printer and part geometry. Use moderate print speeds, enable part cooling set conservatively, and ensure good first‑layer adhesion (brim or raft when needed). Post‑print, allow parts to cool slowly to reduce internal stresses.

Usage recommendations

To achieve the best results with Devil Design PETG Turquoise, verify extrusion flow and retraction settings first on a calibration model, keep the filament dry before printing, and tune cooling and print speed to balance surface finish and strength. Avoid printing in environments with excessive drafts or humidity that can degrade print consistency.