Circular saw blade DeWalt DT1472-QZ — 1 pc, compatible with handheld and table saws

DeWalt DT1472-QZ is a single circular saw blade supplied as one piece and designed for use with both handheld and table saws. It is intended as a replacement accessory for compatible DeWalt and other circular saw models and is suitable for general cutting tasks where a standard multipurpose blade is required. The blade is engineered to handle abrasive materials such as fibre cement and laminate while also performing on a wide range of wood-based and composite panels.

Advantages

The blade features ribbed heat vents that help it run cooler during extended cuts, reducing flex and the risk of binding. It is designed to cut dense composite panels including cement fibre board and provides clean, controlled cuts on laminated and melamine surfaces. The arbor design includes a knock-out section for versatile mounting options, facilitating installation on saws that accept a larger bore.

Suitable for

• Cutting fibre cement and cement fibre board
• Cutting laminate and melamine-faced boards
• General ripping and crosscutting of soft and hardwoods
• Working with MDF, plywood and chipboard
• Use in handheld circular saws and table saws for renovation and carpentry tasks

Key specifications

• Single-piece circular saw blade for handheld and table saws
• Suitable for abrasive materials including fibre cement and laminate
• Ribbed heat vents to reduce blade temperature and flexing
• Arbor designed with a knock-out section to adapt to different bore sizes
• Intended for general-purpose cutting of wood, wood-based panels and dense composites

How to use

Install the blade following the saw manufacturer’s instructions, ensuring the saw is unplugged or the battery is removed before fitting. Verify the arbor sizing and remove the knock-out section if required to match your saw’s bore. Secure the blade firmly, check blade guard and riving knife alignment if present, and set the cutting depth appropriate to the material. Operate the saw at the recommended speed for the blade and material, feed workpieces steadily and support them to avoid binding or kickback.

Usage recommendations

Use appropriate personal protective equipment, including eye and hearing protection and a dust mask when cutting fibre cement or laminate. Allow the blade to cool between long continuous cuts and avoid excessive side pressure that can cause premature wear. For best results on laminated or melamine surfaces, consider using a sacrificial backing support to reduce chipping at the exit edge.