Circular saw blade DeWALT DT1942-QZ 260g 1 pc

The DeWALT DT1942-QZ circular saw blade 260g is a precision cutting accessory engineered for compatibility with DeWALT circular saws. Designed to deliver accurate, clean cuts across a range of materials, this single-piece blade balances tooth geometry and body stability to reduce vibration and improve cut finish. Its moderate weight and rigid construction make it suitable for both trade and DIY environments where consistent performance is required.

Advantages

The blade provides stable cutting performance with a design that minimises vibration and maintains blade runout during operation. Its tooth configuration and hard-wearing cutting edges offer long-lasting sharpness and reliable kerf control. Being a single unit that fits common DeWALT systems, it is straightforward to install and replace, simplifying tool maintenance and reducing downtime.

Suitable for

• Cross-cutting and rip-cutting of softwood and hardwood
• General-purpose woodworking and carpentry tasks
• Trim and finish work requiring clean edges
• Replacement blade for compatible DeWALT circular saws

Key specifications

• Material: high-strength steel body with hardened cutting edges
• Weight: approximately 260 g
• Design: multi-tooth geometry for balanced cutting and reduced vibration
• Compatibility: fits matching DeWALT circular saw models (check saw arbor and blade diameter before use)
• Pack quantity: 1 piece

How to use

Ensure the saw is disconnected from power before fitting the blade. Verify that the blade diameter and arbor size match the saw’s specifications and that the blade rotation direction aligns with the saw’s indicator. Mount the blade securely using the washer and nut supplied with the saw, following the tool manufacturer’s torque recommendations. After installation, perform a test cut on scrap material to confirm correct alignment and safe operation.

Usage recommendations

Use appropriate personal protective equipment, including eye and hearing protection and dust extraction where possible. Select feed rate and blade speed suitable for the material to avoid overheating the cutting edges. Inspect the blade regularly for wear, chipping, or damage and replace it if performance degrades or if any structural defects are observed.