Circular saw blade DeWALT DT1952-QZ 21.6 cm

The DeWALT DT1952-QZ circular saw blade with a 21.6 cm diameter is a replacement cutting blade designed for use with compatible DeWALT circular saws. It is intended to provide precise, clean cuts in common woodworking tasks, offering balanced performance for crosscuts and rip cuts. The blade is supplied as a single unit and its construction supports accurate edge quality and consistent cutting behavior.

Advantages

This circular saw blade delivers stable cutting performance and reduced vibration thanks to its balanced design. The tooth geometry and fine kerf promote cleaner cut surfaces and easier feed through material. At a weight of approximately 500 g, the blade offers a solid feel without overly increasing tool inertia, helping maintain control during operation. The blade is suitable for quick replacement and integrates with compatible DeWALT saws to maintain the tool's intended performance characteristics.

Suitable for

• Crosscutting and ripping of soft and hardwoods
• General carpentry and joinery tasks
• Sheet goods such as plywood and MDF
• On-site cutting where a reliable, single-purpose blade is needed

Key specifications

• Diameter: 21.6 cm
• Weight: approx. 500 g
• Compatibility: fits DeWALT circular saws with matching arbor and diameter
• Cut type: general-purpose woodworking cuts (crosscut and rip)
• Blade construction: carbide-tipped teeth for wear resistance

How to use

Before fitting the blade, ensure the saw is disconnected from its power source. Remove the existing blade following the tool manufacturer's instructions, then mount the DeWALT 21.6 cm blade ensuring correct orientation and secure fastening. Verify blade run-out and tighten the arbor nut to the specified torque. Adjust cutting depth and fence alignment as required for the task. Operate the saw at the recommended speed and feed rate for the material being cut, allowing the blade to reach full speed before engaging the workpiece and supporting the material to avoid pinching the blade.

Usage recommendations

Use appropriate personal protective equipment, including eye and hearing protection and gloves where suitable. For best results, select feed rates and cutting speeds that match the material hardness and thickness; inspect the blade for damage or dulling before each use and replace if teeth are chipped or wear reduces cut quality.