Masonry chisel DeWalt DT6822 flat tip 300 mm, 25 mm cutting edge, 1 pc

DeWalt DT6822 masonry chisel with a flat tip is a hand tool designed for chipping, dressing and removing mortar, brick and other masonry materials. It has an overall length of 300 mm and a 25 mm cutting edge, providing a balance between reach and control for manual hammer work. The chisel is supplied as a single unit with a solid construction intended for use on building sites, restoration projects and general masonry tasks.

Advantages

The flat tip profile ensures consistent contact with masonry surfaces for controlled material removal. At 300 mm length the chisel offers extended reach while remaining manageable for one-handed or two-handed hammer use. The 25 mm cutting edge gives a practical width for breaking out mortar joints and shaping bricks without excessive material removal. The robust, single-piece construction supports repeated impact and reduces the risk of component failure during manual striking.

Suitable for

• Removing mortar from joints
• Chipping and dressing brick or block faces
• Restoration and repair of masonry structures
• General building site tasks requiring a flat chisel

Key specifications

• Tool type: masonry chisel, flat tip
• Overall length: 300 mm
• Cutting edge width: 25 mm
• Construction: single-piece solid steel design for manual hammering
• Intended use: manual chipping, dressing and mortar removal

How to use

Position the flat tip against the mortar, brick or masonry surface at the required angle and strike the chisel with an appropriate hammer to remove material in controlled blows. Use steady, measured impacts rather than excessive force to avoid damaging the masonry or the chisel. For deeper removal work, work progressively along the joint or surface, advancing the chisel in short sections. Wear suitable protective equipment such as safety glasses, gloves and hearing protection during use.

Usage recommendations

Use the chisel with a compatible hand hammer rated for masonry striking; inspect the tool for chips or damage before each use and replace if the cutting edge is badly worn or deformed. Store the chisel dry to prevent corrosion and keep the cutting edge protected when not in use.