Drill bit DeWalt DT8932-QZ, 1 pc, compatible with masonry and concrete (single piece)

DeWalt DT8932-QZ drill bit, single piece, is designed for drilling into masonry and concrete with rotary and hammer drills. The one-piece construction and carbide tip provide the necessary rigidity and wear resistance for standard drilling tasks in building and renovation environments. The bit fits standard drill chucks and is intended for users who need a reliable masonry drilling tool for everyday applications.

Advantages

The single-piece design reduces the risk of joint failure and improves transfer of impact force during hammer drilling. A hardened carbide tip ensures effective penetration of concrete and masonry while maintaining edge retention over repeated use. Compatibility with common drill chucks and both rotary and hammer modes makes this drill bit versatile for a range of on-site tasks.

Suitable for

• Drilling holes in concrete walls and floors
• Fixing anchors, dowels and plugs in masonry
• Light to medium renovation and construction drilling tasks
• Installing fixtures on brick, block, and stone

Key specifications

• Material: steel body with hardened carbide tip
• Design: one-piece construction for impact transfer
• Compatibility: suitable for use in rotary and hammer drilling modes
• Chuck compatibility: fits standard drill chucks
• Intended substrates: masonry, concrete, brick, and stone

How to use

Secure the drill bit in the drill chuck so it is fully seated and tightened. Select the appropriate drilling mode on the drill (rotary for light work, hammer mode for harder concrete or masonry). Begin drilling at low speed to establish a pilot position, then increase speed and apply steady forward pressure; avoid excessive force that could overheat or damage the bit. For deep holes, withdraw the bit periodically to clear dust and debris. After use, clean the bit and store it in a dry place.

Usage recommendations

Use appropriate personal protective equipment such as safety glasses, hearing protection, and dust mask when drilling masonry or concrete. Match drill mode and speed to the substrate: use hammer mode for dense concrete and rotary mode for softer masonry. Keep the bit cool by pausing on long runs and clearing debris frequently to extend tool life.