Table Saw DeWALT DWE7485 — 1850 W, 21 cm blade, 62.2 cm max cutting width, 6.5 cm depth (90°), 5800 RPM

The Table Saw DeWALT DWE7485 is a compact portable power saw designed for accurate rip and cross cuts in construction and workshop settings. It delivers an idle speed of 5800 RPM and a rated output of 1850 W, providing the torque and cutting speed needed for efficient work. The saw accepts a 210 mm blade and provides a maximum cutting depth of 65 mm at 90° and 45 mm at 45°. With a slim tabletop width of 605 mm and the brand's typical three-color design in black, grey and yellow, this model balances mobility with cutting capacity for professionals and hobbyists.

Advantages

The DeWALT DWE7485 combines a high-power motor with a compact footprint to reduce setup time and workspace strain. Its 5800 RPM idle speed supports clean, consistent cuts while the 1850 W power rating maintains performance under moderate load. The 210 mm blade diameter and engineered cutting depth settings provide versatility for common woodworking tasks. The saw's build quality and balanced design make it appropriate for transport between job sites and for use on smaller benches or stands.

Suitable for

• Rip cutting and crosscutting of soft and hardwood boards
• On-site carpentry, framing and finishing work
• Workshop projects where a compact table saw is required
• DIY renovations and furniture making with dimensional lumber

Key specifications

• Idle speed: 5800 RPM
• Rated power output: 1850 W
• Blade diameter: 210 mm
• Maximum cutting depth at 90°: 65 mm
• Maximum cutting depth at 45°: 45 mm
• Tabletop width: 605 mm
• Available colours: black, grey, yellow

How to use

Before operating the saw, ensure the blade is correctly installed and tightened according to the manufacturer's instructions and that the blade guard and riving knife are in place. Set the desired blade height and angle to achieve the specified cutting depths (65 mm at 90°, 45 mm at 45°). Secure the workpiece against the fence and feed it steadily through the blade while maintaining proper hand positions and using push sticks for narrow cuts. Use the fence for straight rip cuts and the miter gauge for crosscuts; avoid freehand cutting. Allow the motor to reach full idle speed (5800 RPM) before commencing each cut for consistent results.

Usage recommendations

For safe and optimal performance, use blades matched to the 210 mm diameter and appropriate tooth geometry for the material. Wear eye and hearing protection, and work on a stable surface. Keep the table surface clean of debris and check blade alignment periodically. For thicker or hardwood stock, use steady feed rates and avoid overloading the 1850 W motor to maintain cut quality and prolong tool life.