Magnetic Angle MW-44 (set of 4), up to 4 kg, DNIPRO-M

Set of four DNIPRO-M Magnetic Angle MW-44 fixtures, each rated to hold metal parts with a maximum load of up to 4 kg. These compact magnetic angles are intended to assist with positioning and securing ferrous components during welding, assembly and alignment operations. The MW-44 units provide stable, repeatable positioning at common angles and free the operator’s hands for tool handling and measurements.

Advantages

The MW-44 magnetic angles are compact and lightweight, allowing easy placement and repositioning on workpieces. Each unit offers a reliable magnetic hold on ferrous metals with consistent contact force for small-to-medium parts. The set of four enables simultaneous support at multiple points or the creation of jigs for repeatable operations. Their simple shape and smooth surfaces make them easy to clean and store after use.

Suitable for

• Holding and aligning steel plates and profiles during welding
• Fixture support during light assembly and fabrication
• Positioning parts for marking, drilling or measuring
• Temporary clamping for repair and maintenance tasks in workshops

Key specifications

• Quantity: set of 4 magnetic angles
• Rated holding capacity: up to 4 kg per unit on clean, flat ferrous surfaces
• Material compatibility: designed for ferrous metals (steel, iron)
• Form factor: compact angled block for simple placement and contact
• Typical applications: welding, assembly, alignment, positioning

How to use

Place each MW-44 magnetic angle directly onto a clean, degreased ferrous surface so the contact faces sit flush. Position the magnetic angles to support the workpiece at the required angle, then bring the mating component into contact with the magnetic faces to establish the magnetic hold. For welding, ensure proper tack welds are applied while the magnetic angles maintain alignment; for drilling or marking, confirm alignment before proceeding. Remove by sliding slightly to break the magnetic contact or by lifting from one edge once the workpiece is secured by other means.

Usage recommendations

Use the MW-44 magnetic angles only on flat, ferrous surfaces to achieve the stated holding capacity. Avoid using on stainless steel, non-ferrous metals, painted or heavily rusted surfaces where magnetic grip is reduced. Keep contact faces clean and free of debris; store in a dry environment to avoid corrosion. Do not exceed the rated holding capacity per unit and use multiple units for larger or heavier assemblies to distribute load and improve safety.