Diamond cutting disc DNIPRO-M CERAMICS Ø125×1.4×22.2 mm for ceramic tiles

Diamond cutting disc DNIPRO-M CERAMICS Ø125×1.4×22.2 mm is designed for accurate cutting of ceramic tiles, porcelain and similar hard brittle materials. The 125 mm diameter and 1.4 mm cutting width allow for precise straight cuts with minimal material loss. The 22.2 mm centre hole fits most standard tile saws and angle grinders. The disc is suitable for both wet and dry cutting and is aimed at renovation, tiling and professional installation work where clean, chip-resistant edges and predictable service life are required.

Advantages

The disc provides a thin kerf that reduces wasted material and decreases cutting load on the machine. Segmented diamond edge and balanced construction deliver smooth, chip-minimising cuts on glazed ceramic and porcelain. Compatibility with wet and dry cutting increases versatility on job sites. The disc construction is engineered for extended wear, keeping cutting performance consistent during prolonged use.

Suitable for

• Cutting ceramic wall and floor tiles
• Trimming porcelain and vitrified tiles
• On-site adjustments during renovation and installation
• Use with angle grinders and small tile saws

Key specifications

• Disc diameter: 125 mm
• Kerf (cutting width): 1.4 mm
• Arbor (bore) diameter: 22.2 mm
• Material type: diamond abrasive edge for ceramic and porcelain
• Suitable cutting methods: wet and dry

How to use

Mount the diamond cutting disc on the grinder or tile saw following the machine manufacturer’s instructions, ensuring the disc is securely fastened and the tool is unplugged or battery removed while fitting. For dry cutting, use steady, even feed pressure and avoid excessive force to reduce overheating; for wet cutting, maintain appropriate water flow to cool the disc and flush debris. Allow the disc to reach full speed before contacting the workpiece and support the tile firmly to prevent vibration and chipping. Replace the disc when cutting performance noticeably decreases or if the disc shows visible damage.

Usage recommendations

Use appropriate personal protective equipment—safety glasses, gloves, hearing protection and a dust mask when dry cutting. Follow the angle grinder or saw manufacturer's speed rating and never exceed the maximum RPM marked on the disc. For consistent edge quality on glazed tiles, perform a light finish pass after the initial cut and keep the workpiece well supported.