Grinding disc for tiles and stone DNIPRO-M P100 100 mm

Diamond grinding disc DNIPRO-M P100, 100 mm diameter, is engineered for grinding, shaping and smoothing ceramic tiles and natural stone surfaces. Compatible with angle grinders and tile grinders that accept 100 mm discs, this accessory is intended to deliver consistent material removal and accurate edge finishing during renovation, installation and finishing operations. The disc’s diamond abrasive and balanced construction provide controlled cutting behavior and predictable wear when used according to recommended operating parameters.

Advantages

The DNIPRO-M P100 grinding disc offers high abrasive efficiency on ceramic and stone materials, enabling faster stock removal while maintaining a stable grinding surface. Its 100 mm diameter and segmented diamond edge allow for precise edge profiling and chamfering, reducing the need for secondary manual finishing. The design promotes consistent wear and reliable performance across a range of tile and natural stone densities, while remaining compatible with common 100 mm angle and tile grinders.

Подходит для

• Подготовка к укладке и обрезка кромок керамической плитки
• Финишная обработка и сглаживание граней натурального камня
• Выравнивание краёв и снятие фаски при ремонте и отделке
• Работы по огранке и коррекции размеров плит в ограниченных пространствах

Key specifications

• Diameter: 100 mm
• Abrasive type: diamond grit
• Grit grade: P100 (medium)
• Intended materials: ceramic tiles, porcelain, natural stone
• Compatible tool type: angle grinders and tile grinders for 100 mm discs
• Typical mounting: 22.23 mm arbor (standard for 100 mm discs) — verify your tool’s arbor before use

How to use

Mount the DNIPRO-M P100 disc on an appropriate 100 mm grinder following the tool manufacturer’s instructions and ensure the arbor and fastening flange are compatible and secure. Use appropriate rotation direction markings if present. When grinding tiles or stone, operate the grinder at recommended speed ranges for the tool, apply light, even pressure and move the disc steadily along the workpiece to avoid overheating and uneven wear. Allow the diamond surface to do the cutting; avoid forcing the disc. Use water cooling only if the disc and tool permit it; otherwise perform dry grinding with frequent pauses to prevent overheating.

Рекомендации по использованию

Always wear suitable personal protective equipment: eye protection, hearing protection, gloves and a dust mask or respirator suitable for mineral dust. Secure the workpiece before grinding and keep bystanders away. Inspect the disc before use for damage or excessive wear and replace if necessary. Follow the grinder manufacturer’s maximum RPM rating and the disc’s safe speed limits. For best results, test on a scrap piece to set feed rate and pressure.

Нейтральный, технически ясный текст ориентирован на использование диска при подготовке поверхности и точной финишной обработке керамики и камня в профессиональных и домашних проектах.