Pipe cutter Drel MINI 3 — for pipes Ø up to 22 mm, compact manual tubing cutter

Drel MINI 3 pipe cutter is a compact manual tubing cutter designed for cutting pipes and tubes with an outer diameter up to 22 mm. The tool has a small lightweight body for one-handed operation, a hardened cutting wheel for clean crosscuts and an adjustable clamping mechanism that secures the tube during cutting. Suitable for copper, brass and common plastic tubing, this cutter is intended for plumbing, HVAC and DIY tasks where precise, burr-free cuts and portability are required.

Advantages

The compact size and light weight of the Drel MINI 3 make it easy to use in confined spaces and overhead positions, while the single-handed operation speeds up repetitive work. The hardened cutting wheel produces consistent, clean crosscuts with minimal deformation of the tube end. The adjustable clamping system holds pipes firmly to reduce slipping and ensure straight cuts. The overall design minimizes the need for final deburring and simplifies handling during installation.

Suitable for

• Cutting copper plumbing pipes up to 22 mm outer diameter
• Trimming brass tubing for fittings and connectors
• Cutting common plastic pipes and tubing for HVAC and domestic installations
• On-site repairs and tight-space pipework where portability is needed

Key specifications

• Maximum cut capacity: outer diameter up to 22 mm
• Tool type: compact manual pipe/tubing cutter
• Cutting element: hardened cutting wheel for clean crosscuts
• Operation: one-handed use with adjustable clamping mechanism
• Suitable materials: copper, brass, common plastic tubing
• Body: small, lightweight design for confined spaces

How to use

Place the tube inside the cutter so the cutting wheel aligns with the intended cut mark. Tighten the clamping mechanism until the cutting wheel contacts the tube, then rotate the tool evenly around the pipe while gradually increasing clamping pressure every few turns. Continue rotating and tightening in small steps until the tube is cut through cleanly. Inspect the cut face and remove any burrs if necessary before joining or installing the pipe.

Usage recommendations

For best results, ensure the cutting wheel is clean and free of nicks; replace the wheel if cuts become rough or require excessive force. Use steady, even rotations and incremental tightening rather than forcing the tool. After cutting metal pipes, remove burrs with an appropriate deburring tool or file to ensure proper sealing and fit. Store the cutter in a dry place to prevent corrosion of the cutting wheel and moving parts.