Power Supply ECOLIGHT2 EC20124 — 12V 1.25A 15W IP67 for Junction Box

ECOLIGHT2 EC20124 is a compact 12V DC constant-voltage power supply delivering up to 1.25A (15W) with IP67 ingress protection. Engineered for installation in a junction box, this sealed unit provides a weather-resistant power source for low-voltage LED strips, small fixtures and short lighting circuits. Its rated output and enclosure protection make it suitable for both indoor and outdoor environments where dust and temporary water exposure are possible.

Advantages

The ECOLIGHT2 EC20124 combines a stable 12V constant-voltage output with an IP67-rated enclosure to ensure reliable operation in damp or dusty conditions. Its compact dimensions allow installation inside standard junction boxes, reducing visible wiring and simplifying integration into existing electrical installations. The unit’s 15W power rating is suited to drive short LED runs or multiple small fixtures while maintaining regulated voltage to protect connected loads.

Suitable for

• Powering 12V LED strips and modules in kitchens, bathrooms and outdoor soffits
• Supplying small low-voltage LED fixtures and spotlights
• Sealed installations inside junction boxes exposed to dust or splash water
• Short-run landscape or signage lighting where a compact sealed PSU is required

When it may not be suitable

This power supply provides a maximum of 15W and is not suitable for longer LED runs or high-power LED fixtures that require higher current or wattage. It is intended for constant-voltage 12V loads and should not be used with devices that require constant-current drivers or higher DC voltages. For fully submerged installations or locations requiring additional mechanical protection, a more specialized enclosure may be necessary.

Key specifications

• Output voltage: 12 V DC (constant voltage)
• Maximum output current: 1.25 A
• Maximum output power: 15 W
• Ingress protection: IP67 (dust-tight and protected against temporary immersion/splashing)
• Designed for installation in a junction box; compact enclosure suitable for concealed mounting
• Intended for low-voltage LED loads and small lighting circuits

How to use

Install the ECOLIGHT2 EC20124 inside a suitable junction box following local electrical codes. Ensure mains power is switched off before making connections. Connect the AC input conductors to the mains terminals and the 12V DC output to the LED load observing correct polarity. Securely fasten wiring and verify that the junction box provides adequate strain relief and sealing where cables enter. After wiring, restore power and measure output voltage to confirm correct operation before finalizing the installation.

What to consider before purchase

• Confirm total load does not exceed 15W and 1.25A at 12V
• Verify that connected LEDs require a constant-voltage 12V supply rather than constant-current
• Ensure the chosen junction box accommodates the unit’s dimensions and wiring entry methods
• Check environmental requirements—IP67 offers strong protection but not intended for permanent submersion without additional enclosure considerations

Usage recommendations

For reliable performance, match the combined wattage of connected LED strips and fixtures to remain below the 15W rating and allow margin for inrush currents. Use heat-dissipating mounting practices within the junction box and ensure cable glands or seals preserve the IP67 integrity at cable entry points.