Leave your address - as soon as the price of the product goes down, you'll know about it right away
SATA cable Eigenbrand Goobay 50915 — SATA II 7-pin, 0.5 m, red
SATA cable Eigenbrand Goobay 50915 — SATA II 7-pin, 0.5 m, red
In cart {{totalProductsCount}} item(s)
Your cart is empty
SATA cable Eigenbrand Goobay 50915 — SATA II 7-pin, 0.5 m, red
Leave your address - as soon as the price of the product goes down, you'll know about it right away
SATA cable Eigenbrand Goobay 50915 — SATA II 7-pin, 0.5 m, red
SATA cable Eigenbrand Goobay 50915 — SATA II 7-pin, 0.5 m, red
The Eigenbrand Goobay 50915 SATA cable is a red 0.5 m internal data cable with two L-shaped SATA 7‑pin connectors, designed to connect SATA storage devices such as hard disk drives and solid‑state drives to a motherboard or SATA controller. It supports SATA II transfer rates up to 3.0 Gbit/s and is supplied as a single bulk piece. The cable is intended for standard internal PC data connections and is compliant with WEEE disposal regulations.
The cable offers a compact 0.5 m length suitable for routing inside desktop and small form factor systems while minimizing excess slack. Its SATA II specification ensures compatibility with a wide range of SATA devices and controllers that operate at 3 Gbit/s. The red jacket helps identify data paths and can aid in tidy cable management within a chassis. Connectors on both ends are L‑type SATA 7‑pin male, providing the common right‑angle fit used in many modern PC builds.
Power off the computer and disconnect it from mains before installing the cable. Align the L‑shaped 7‑pin SATA connector with the female SATA port on the drive and insert it gently until it seats. Connect the other end to the motherboard or SATA controller port in the same way. After securing connections and any necessary drive mounting, reconnect power and boot the system to confirm the drive is recognized by the BIOS/UEFI or operating system.
For reliable operation, avoid bending the cable at sharp angles and keep it clear of fans and high‑heat components. Use the 0.5 m length for short internal runs to reduce clutter, and inspect connectors for damage before installation. Dispose of the cable in accordance with local WEEE/electronic waste regulations when no longer needed.
{{highlightedFeature.featureTitle}}:
{{getProductFeatureValueById(product, highlightedFeature.featureId)}}