Portable gas detector electro base HT66 — combustible gases (methane) detection up to 10% FS

The electro base HT66 portable gas detector is designed to measure concentrations of combustible gases, primarily methane, up to 10% of full scale (FS). Compact and lightweight, this handheld instrument offers straightforward on-site monitoring for leak detection, routine safety checks and maintenance tasks across industrial, commercial and residential environments. The device provides immediate concentration readings to support timely decisions and corrective action when elevated gas levels are detected.

Advantages

The HT66 combines a focused detection range for methane and similar flammable gases with a simple user interface, enabling quick interpretation of results. Its compact form factor and battery-powered operation make it suitable for mobile inspections and confined-space checks. The detector’s measurement range up to 10% FS is appropriate for early leak identification and operational monitoring where coarse-to-moderate concentration detection is required.

Подходит для

• Проверки утечек природного газа (метана) в бытовых и коммерческих помещениях
• Оперативного контроля концентрации горючих газов в производственных зонах
• Рутинной проверки оборудования и трубопроводов при техническом обслуживании
• Быстрых инспекций в труднодоступных или мобильных условиях

Key specifications

• Measured gas type: combustible gases with focus on methane
• Detection range: up to 10% of full scale (FS)
• Form factor: handheld, portable
• Power: battery-powered for mobile use
• User interface: simple display for direct concentration readout
• Typical applications: leak detection, safety checks, maintenance monitoring

How to use

Power the unit according to the manufacturer instructions and allow the detector to perform any required warm-up or sensor stabilization period. Hold the detector near the area to be checked, moving the probe or sensor inlet slowly along joints, valve connections, pipe runs and equipment surfaces where leaks are likely. Observe the instrument display for concentration readings; if values approach or exceed expected safety thresholds, follow established site procedures to isolate the source and ventilate the area. Turn the unit off after use and store it according to the recommended conditions to protect the sensor.

Usage recommendations

Ensure regular functional checks and periodic sensor calibration or replacement as specified by the manufacturer. Use the detector for initial screening and mobile inspections, and confirm critical results with fixed monitoring systems or laboratory analysis when required by safety procedures or regulations.