Cable pulling sock electro base ROD-Gx3L-8-15mm 3x loops Ø8–15 mm length 500 mm

Cable pulling sock electro base ROD-Gx3L-8-15mm is a woven mesh cable grip intended for pulling and guiding round cables with diameters from 8 to 15 mm. The device has three attachment loops and a total length of 500 mm to provide even load distribution and improved control during installation. The open mesh design conforms to the cable surface to reduce snags and protect conductors while feeding through conduits, ducts or tight pathways.

Advantages

The three-loop configuration enables secure fastening to winches, ropes or swivel hooks and distributes tensile forces across a larger area of the cable. The 500 mm length offers sufficient bite on the cable for stable handling without excessive bulk. The mesh construction provides flexibility to adapt to slight variations in cable diameter while maintaining grip, and the design minimizes friction and catching when pulling through bends or entry points.

Suitable for

• Pulling single round power or control cables of 8–15 mm diameter
• Installing telecom and data cables through conduits and ducts
• Routing cables in construction, renovation and utility works
• Temporary anchoring to winches, hand lines or pulling rigs

Key specifications

• Compatible cable diameter range: 8–15 mm
• Configuration: mesh cable grip with three attachment loops
• Overall length: 500 mm
• Construction: flexible woven mesh for conforming grip
• Attachments: three reinforced loops for secure connection

How to use

Slide the narrow end of the mesh over the cable end and pull the grip along until the mesh tightens around the cable body. Position the grip so the load is distributed along the cable within the mesh length, then attach a suitable pulling line, winch hook or swivel to one of the loops. Apply steady tension when pulling and avoid shock loads. After installation, release tension and slide the mesh off the cable end.

Usage recommendations

Inspect the cable and grip before use for damage or excessive wear. Select the attachment loop appropriate for the pulling angle to reduce side load. Do not exceed the rated pulling force of the cable being installed; use a larger or additional grips for heavier cables or longer pulls. Store the mesh grip clean and dry to maintain flexibility and performance.