Manual Fire Alarm Call Point Elektromet WPp-2s ROP A 2Z 12A NO-NO IP65 (921552)

The Manual Fire Alarm Call Point Elektromet WPp-2s ROP A 2Z 12A NO-NO IP65 is a surface-mounted, break-glass type actuator designed for manual activation of fire alarm circuits. Constructed for use in both indoor and outdoor environments, the unit features IP65 ingress protection and a robust enclosure that withstands dust and low-pressure water jets. Its two-zone configuration and 12A switching capacity deliver basic circuit switching with normally open contacts suitable for commercial and industrial fire alarm installations.

Advantages

This call point combines a simple, recognizable break-glass actuation with a durable, weather-resistant housing rated IP65, making it suitable for exposed locations. The dual normally-open contact arrangement provides flexibility for wiring into multi-zone or redundant alarm circuits. With a 12A switching capacity, it supports reliable operation of connected signalling and control devices without requiring complex auxiliary components.

Suitable for

• Manual alarm activation in commercial buildings
• Industrial sites and production facilities
• Outdoor installations exposed to dust and water spray
• Multi-zone fire alarm systems requiring separate contact circuits

Key specifications

• Mounting: surface-mounted enclosure
• Actuation type: break-glass (manual)
• Contact configuration: two normally-open contacts
• Switching capacity: 12 A
• Zones: two-zone capability
• Ingress protection: IP65 (dust-tight and protected against water jets)
• Suitable environment: indoor and outdoor use

How to use

Install the call point on a flat surface at an accessible height according to applicable fire safety standards and local regulations. Connect the alarm wiring to the two normally-open contacts following the system wiring diagram and ensure secure terminal connections. For manual alarm activation, break the glass or press the designated actuator according to the device design; this will close the contacts and send a signal to the alarm control panel. After activation, replace the break-glass element or reset the actuator as required by the specific model maintenance procedure.

Usage recommendations

Place call points in clearly visible, unobstructed locations near exits, stairwells, and high-traffic areas. Verify IP65 sealing after installation and periodically inspect for physical damage, corrosion, or moisture ingress. Test circuits and contacts during routine maintenance to confirm reliable switching at the specified 12A rating and follow local fire code requirements for spacing and number of manual call points.