Cable holder (round) ELEKTROPLAST FLOP-3 model 27.03 for Ø3 mm cables, pack 100 pcs

Round cable holder ELEKTROPLAST FLOP-3 model 27.03 is designed to secure round cables with a diameter of 3 mm. Supplied in a pack of 100 pieces, these clips are intended for fixed fastening of electrical and low-voltage wiring along walls, inside cabinets, or on mounting rails. The FLOP-3 design provides a compact, low-profile clip for neat cable routing and organization in installations, repairs and maintenance tasks.

Advantages

The ELEKTROPLAST FLOP-3 offers a simple, consistent method to fasten Ø3 mm round cables without the need for additional ties. Each clip is compact and designed to minimize space usage while keeping cables secure. The pack of 100 pieces ensures an economical supply for larger wiring runs or multiple small projects. The clip’s shape supports easy insertion and holds the cable in place to reduce movement and wear.

Suitable for

• Routing and fixing single round electrical or low-voltage cables with 3 mm diameter
• Neat cable management in residential and commercial electrical installations
• Securing wiring inside junction boxes, enclosures, cabinets and panels
• Maintenance, servicing and retrofit projects requiring multiple small clips

When it may not be suitable

This round cable holder is intended specifically for cables around 3 mm in diameter; cables with significantly larger or smaller diameters may not fit securely. It is not a load-bearing support for heavy cable bundles or for cables that require strain relief under mechanical tension. Use for outdoor exposed locations or chemically aggressive environments should be evaluated against the clip material’s resistance and local installation standards.

Key specifications

• Cable diameter accommodated: 3 mm (round)
• Quantity per pack: 100 pieces
• Mounting type: fixed clip for surface or enclosure mounting
• Typical application: electrical and low-voltage cable routing and securing
• Design: low-profile round clip for minimal visual impact

How to use

Position the FLOP-3 clip where the cable run requires support, then secure the clip to the surface or inside an enclosure using an appropriate fastener (screw or rivet) through the clip’s mounting hole. Insert the Ø3 mm cable into the rounded clip opening until it is held firmly. Space clips at regular intervals along the run to prevent sagging and to maintain cable organization. Follow local electrical codes and best practices for mounting spacing and securing methods.

What to consider before purchase

• Verify cable outer diameter is approximately 3 mm for a secure fit
• Ensure the clip material and mounting method suit the installation environment (indoor, protected enclosures)
• Confirm quantity (100 pieces) meets the scope of your project
• Check compatibility with the chosen fastener type (screw, rivet) and mounting surface

Usage recommendations

For reliable results, space clips at consistent intervals (commonly every 30–50 cm for single light cables) and avoid over-tightening mounting fasteners which can deform the clip. For runs with multiple cables or heavier wiring, use appropriately sized clips or additional support to ensure long-term stability.