Flat cable clamp ELEKTROPLAST OMYP 2x0.5 FLOP-5/3, pack 100

Flat cable clamp ELEKTROPLAST OMYP 2x0.5 FLOP-5/3, supplied in a pack of 100, is a compact fastening clip designed for secure routing and fixing of flat twin conductors with 2×0.5 mm² cross-section. The clamp provides a mechanical hold on the insulated conductors, enabling neat cable runs along walls, panels and inside enclosures. It is intended for use in residential and light-commercial electrical installations and repair work where simple, reliable cable management is required.

Advantages

The ELEKTROPLAST OMYP clamp offers a small footprint and consistent clamping force to keep flat cables in place without damaging insulation. Supplied in a bulk pack of 100 pieces, it supports efficient installation and inventory management. The design allows quick mounting to flat surfaces and provides a tidy finish for visible cable runs.

Suitable for

• Securing flat twin conductors 2×0.5 mm² along walls and skirting boards
• Router, TV and low-voltage signal cable routing in homes
• Temporary or permanent cable fixing during repairs and maintenance
• Neat cable management inside distribution boxes and small enclosures

Key specifications

• Compatible conductor cross-section: flat twin 2×0.5 mm²
• Material: durable insulating plastic suitable for indoor use
• Mounting method: surface-mounted clip for screws or adhesive (depends on installer method)
• Pack quantity: 100 pieces
• Application environment: residential and light-commercial electrical installations

How to use

Position the clamp over the flat cable at the desired location and secure it to the surface using an appropriate screw or adhesive suitable for the mounting substrate. Ensure the cable sits fully in the clip without excessive force on the conductor insulation. Space clamps at regular intervals to maintain an even cable run and avoid strain on terminations. For replacement or repositioning, remove the fastener and reinstall at the new location following the same procedure.

Usage recommendations

Use clamps at recommended spacing for 2×0.5 mm² conductors to prevent sagging and mechanical stress. Avoid overtightening screws to prevent deformation of the clip and potential damage to cable insulation. Select mounting fasteners appropriate for the surface material and indoor environment.