LED reflector EMOS Hobby Slim 2x30W 4800LM on tripod — work light

LED reflector EMOS Hobby Slim 2x30W 4800LM on tripod — work light provides focused, broad-spectrum illumination for work and hobby environments. The unit combines two slim LED panels, each rated at 30 W, delivering a combined luminous flux of approximately 4800 lumens. Mounted on a lightweight adjustable tripod, the reflector enables quick setup and stable, hands-free operation while allowing directional adjustment of the light panels to target specific work areas.

Advantages

The dual-panel LED design offers even light distribution with reduced shadowing compared to a single source, while the high luminous flux ensures sufficient brightness for indoor workshops and outdoor tasks. The slim housing and efficient LEDs contribute to lower power consumption and heat generation relative to older halogen alternatives. The adjustable tripod provides flexible height and angle positioning for varied jobsite requirements, and the compact, portable form factor supports easy transport and storage.

Suitable for

• Workshop bench lighting and garage repairs
• Construction and renovation sites
• Outdoor projects, gardening and evening tasks
• Hobby stations, DIY projects and model building
• Emergency or temporary lighting during power outages

Key specifications

• Light output: approximately 4800 lumens (combined)
• Power: two 30 W LED panels (total 60 W)
• Color temperature: neutral daylight range (ideal for accurate color rendering)
• Mounting: adjustable tripod with height and angle adjustment
• Housing: slim, lightweight construction for portability
• Beam characteristics: wide-area coverage with minimized hot spots

How to use

Place the tripod on a stable, level surface and extend the legs to the required height, then secure the leg locks. Attach or lock the reflector assembly to the tripod head and adjust the angle of each LED panel to illuminate the target area. Connect the reflector to a suitable mains supply following the product’s safety markings and local electrical regulations. For directional work, tilt or rotate the panels independently until the desired coverage and shadow reduction are achieved.

Usage recommendations

Place the tripod on stable ground and avoid positioning directly in walkways to reduce trip hazards. Allow for adequate ventilation around the reflector housing during extended operation. For tasks requiring precise color assessment, position the reflector to minimize reflected glare and maintain a consistent distance from the work surface.