The Inflator Pump Enero standard for SUP boards 2.2L, max 25 PSI is a manual hand pump designed to inflate and maintain stand-up paddle (SUP) boards. With a 2.2-litre air chamber and a maximum pressure rating of 25 PSI, the pump supports both single- and dual-action inflation modes depending on the model configuration and adapter used. It is compatible with common SUP valves and intended for recreational paddlers who require a portable, easy-to-operate solution for inflating boards at home, on the beach, or while traveling.
Advantages
The pump combines a compact, lightweight design with a relatively large 2.2 L air chamber that reduces the number of strokes needed compared with smaller pumps. A maximum working pressure of 25 PSI covers the typical inflation range for many recreational and touring SUP boards. The manual operation ensures independence from electrical power and simple maintenance, while compatibility with standard SUP valves makes it usable across a wide range of boards and conditions.
Suitable for
- Inflating recreational and touring SUP boards up to recommended pressures
- On-site pump-up at the beach, at home, or during trips
- Maintaining board pressure before and during paddling sessions
Key specifications
- Air chamber capacity: 2.2 L
- Maximum pressure: 25 PSI
- Operation: manual single- and dual-action (model-dependent)
- Compatibility: fits common SUP inflation valves with included or standard adapters
- Typical use: portable hand pump for SUP boards and similar inflatable water equipment
How to use
Attach the appropriate valve adapter to the pump head and connect it securely to the SUP valve. Use the pump in single-action mode for greater air volume per stroke or dual-action mode if the pump supports it for faster inflation. Monitor the board pressure with an inline gauge if available or by feel; stop inflating when the board reaches the manufacturer’s recommended PSI, not to exceed 25 PSI. Disconnect the pump head, replace the valve cap on the board, and store the pump dry to prevent corrosion and wear.
Usage recommendations
For consistent board performance, inflate the SUP to the manufacturer’s recommended pressure and check pressure before each use. Avoid exceeding 25 PSI. Rinse and dry the pump after use in saltwater environments and store it in a shaded, cool place. If the pump offers both single- and dual-action modes, begin with dual-action to reach base pressure quickly, then switch to single-action for fine-tuning to the exact PSI.
