Facade Putty Knife EPM E-314-0550 — stainless steel, 50 mm blade, 550 mm handle

EPM E-314-0550 is a facade putty knife featuring a 50 mm stainless steel blade combined with a long 550 mm handle. The tool is designed for application, smoothing and levelling of facade putties and renders on exterior surfaces. Stainless steel construction of the blade provides corrosion resistance for outdoor use while the extended handle length helps reach higher areas and improves control during finishing work.

Advantages

The stainless steel blade resists rust and maintains a consistent edge for clean spreading and smoothing of putty and render. A 50 mm blade width offers precision for narrow joints and patching work while still covering small surface areas efficiently. The 550 mm handle increases reach and leverage, reducing the need for ladders or frequent repositioning when working on façades. The tool’s balanced design supports steady application and uniform surface results.

Suitable for

• Applying and smoothing facade putties and renders
• Patching cracks and small damaged areas on exterior walls
• Levelling narrow seams and edges around windows and architectural details
• Finishing work on plaster and cement-based coatings in outdoor conditions

Key specifications

• Blade material: stainless steel
• Blade width: 50 mm
• Handle length: 550 mm
• Intended use: exterior façade putty and render application
• Construction: single-piece blade with attached handle for extended reach

How to use

Prepare the surface by cleaning dust, loose material and any contaminants to ensure good adhesion. Load an appropriate amount of facade putty or render onto the 50 mm stainless steel blade and apply with steady pressure along the repair area or seam. Use sweeping, even strokes to spread and level the material, working from the centre of the application outward to avoid ridges. For higher areas, use the extended 550 mm handle to maintain control without overreaching; check the surface and perform a light follow-up pass for final smoothing once the material begins to set.

Usage recommendations

After use, clean the stainless steel blade promptly with water and a mild detergent to remove residual putty or render. Store the tool dry and inspect the blade periodically for deformation; replace if significantly bent or worn to maintain application quality. For best results, use the putty knife with compatible exterior-grade putties and renders and follow manufacturer instructions for the materials applied.