Crimp Female Spade Connector Erko TS 6.3 mm for 6 mm² Wires, Pack of 100

Erko TS 6.3 mm female crimp spade connectors are uninsulated terminals designed for reliable mechanical and electrical connection to conductors with a 6 mm² cross-section. Supplied as a pack of 100 pieces, these spade terminals accept a 6.3 mm blade width and are intended for direct crimping onto copper conductors to form secure detachable connections for panel, automotive and industrial wiring.

Advantages

These uninsulated female spade connectors provide a compact, low-resistance connection when correctly crimped, enabling repeatable mating and unmating with male blades. Their metal construction ensures good conductivity and mechanical strength, while the 6.3 mm blade width is a common standard that fits a wide range of male terminals. The pack quantity of 100 pieces offers economy for larger assemblies or routine maintenance tasks.

Suitable for (tasks / use cases)

• Panel wiring and terminal blocks where removable blade connections are required
• Automotive and vehicle electrical connections for lights, switches and accessories
• Industrial control panels and machinery requiring serviceable connections
• Repair or replacement of existing 6.3 mm blade female terminations

When it may not be suitable

Because these spade connectors are uninsulated, they are not suitable where insulation or protection against short circuits and accidental contact is required. They are intended for use with conductors of approximately 6 mm² cross-section; using significantly smaller or larger conductors will result in poor crimp quality and unreliable electrical contact. For applications requiring sealed, insulated, or waterproof connections, choose appropriately rated insulated or sealed terminals instead.

Key specifications

• Terminal type: Female crimp spade (uninsulated)
• Blade width: 6.3 mm
• Suitable conductor cross-section: 6 mm² (copper conductors)
• Material: conductive metal suitable for crimped connections
• Pack quantity: 100 pieces

How to use

Strip the conductor to the recommended length, insert the bare conductor fully into the barrel of the spade connector, and apply a suitable crimping tool matched to the terminal size to form a secure mechanical and electrical joint. After crimping, inspect the connection to ensure the conductor is firmly held and there is no exposed loose strand. Mate the crimped female spade with a matching 6.3 mm male blade until fully engaged. For repeated service, avoid excessive bending or movement of the cable at the crimped joint.

What to consider before purchase

• Confirm conductor cross-section is 6 mm² and that the application uses 6.3 mm blade male terminals
• Decide whether uninsulated terminals are acceptable for voltage and safety requirements of the installation
• Ensure you have the correct crimping tool for reliable, gas-tight crimps
• Consider corrosion exposure and choose plated or protected terminals if needed

Usage recommendations

Use a dedicated crimping tool sized for 6 mm² terminals, check each crimp for mechanical retention and electrical continuity, and avoid using these uninsulated spades in environments where contact protection or sealing is required.