Power Supply eSPe LNF-15024 — LED switching power supply 24V 150W 6.25A IP20

eSPe LNF-15024 is an LED switching power supply that provides a stable 24 V DC output with a maximum continuous current of 6.25 A and total output power of 150 W. With IP20 protection, this unit is intended for indoor installations where centralized, constant-voltage power is required for LED strips, modules and lighting systems. The compact design and standardized electrical characteristics make it suitable for both residential and commercial lighting applications that need reliable DC supply for LED components.

Advantages

The device delivers regulated 24 V output and up to 6.25 A of current, ensuring consistent light performance across connected LED loads. A switching topology increases conversion efficiency and reduces heat output compared with simple linear supplies. The IP20 rating confirms suitability for dry indoor environments and installation inside equipment enclosures or distribution boxes. Built-in protections and stable voltage help prevent flicker and reduce stress on LED components.

Suitable for

• Powering 24 V LED strips in indoor accent or task lighting
• Supplying LED modules and light bars in retail or office fixtures
• Centralized power for residential under-cabinet and cove lighting
• Low-voltage LED installations inside cabinets, housings or control panels

Key specifications

• Output voltage: 24 V DC
• Maximum output current: 6.25 A
• Maximum output power: 150 W
• Input type: AC switching power input (standard mains voltage range)
• Protection rating: IP20 (indoor, dry locations)
• Cooling method: convection cooling (no forced fan)

How to use

Install the power supply in a well-ventilated indoor location protected from moisture and dust. Connect the AC mains input following local electrical codes and ensure the supply is switched off while wiring. Connect the 24 V DC output to the LED load, observing correct polarity and ensuring the combined load does not exceed 150 W or 6.25 A. Allow for adequate spacing around the unit for heat dissipation and secure the device inside an enclosure or mounting surface as required.

Usage recommendations

For reliable operation, match the LED load to the 24 V constant-voltage output and keep the total connected power below the rated 150 W. Use appropriately sized wiring and fuses or circuit breakers on the mains side and consider a dedicated DC distribution if multiple LED runs are required. Avoid installation in wet or outdoor locations due to the IP20 rating.