Tube cutter EXEC VT1501 for PEX pipes, cutting capacity 3–42 mm

The Tube cutter EXEC VT1501 for PEX pipes is a handheld cutting tool designed for manual trimming of polymer plumbing and heating pipes with diameters from 3 to 42 mm. The tool delivers clean cross-cuts on PEX and similar plastic pipes, intended for on-site repair, replacement and installation work where straightforward, accurate cuts are required. The compact, ergonomic form supports one-handed operation and straightforward positioning around the pipe.

Advantages

The cutter provides a consistent cutting capacity across a wide diameter range, allowing use with small and medium-sized PEX lines without changing tools. Its sharp blade ensures minimal burr formation and smooth pipe ends that facilitate reliable joint connections. The simple mechanical design reduces maintenance needs and enables quick, repeatable cuts in confined spaces and on scaffolding or ladders.

Suitable for

• Cutting PEX and other polymer pipes with diameters between 3 mm and 42 mm
• Plumbing installation and repair work in residential and commercial buildings
• Heating system pipe trimming and preparation for fittings
• On-site service tasks where a portable manual cutter is required

Key specifications

• Cutting capacity: 3–42 mm diameter
• Tool type: handheld manual tube cutter
• Intended pipe material: PEX and similar polymer pipes
• Cut type: clean cross-cuts suitable for fittings and connectors
• Operation: manual one-handed positioning and cutting mechanism

How to use

Place the pipe into the cutter’s opening at the required cutting point and align the blade for a perpendicular cross-cut. Secure the tool around the pipe, apply steady manual pressure and rotate or squeeze as the tool design requires until the pipe is fully separated. Inspect the cut end for burrs or deformities and, if necessary, remove minor burrs with a deburring tool or fine file to ensure a smooth surface for fittings. Follow standard safety practices such as wearing protective gloves and eye protection when cutting.

Usage recommendations

For best results, use the cutter only on pipes within the specified diameter range and avoid cutting metal or reinforced lines not intended for this tool. Keep the blade clean and sharpened or replaced when cuts become uneven. Store the cutter in a dry place to prevent corrosion of metal components and check moving parts periodically for wear.