Try Square T-Type Expert+ MN-83-040 300 x 600 mm

The Try Square T-Type Expert+ MN-83-040 300 x 600 mm is a T-shaped precision measuring tool designed for establishing and checking right angles in carpentry, metalwork and general workshop tasks. With a rigid cross-piece and a long blade, this try square supports layout, alignment and quality control of edges, corners and perpendicular surfaces. Its 300 x 600 mm dimensions provide an extended reference for larger panels and components while remaining suitable for bench and on-site use.

Advantages

The tool combines a stable T-frame with a long straight blade to minimise flex and ensure consistent 90° alignment across the full length. Its size allows both short and extended measurements without changing tools. The construction is intended to resist warping and maintain squareness under regular workshop conditions, supporting repeatable layout and inspection tasks.

Suitable for

• Checking and marking right angles on boards, panels and sheets
• Layout and squaring of frames, cabinets and furniture components
• Edge and face alignment in metal fabrication and welding preparation
• Quality control and inspection of perpendicularity in production
• Hobby and DIY projects requiring accurate 90° references

Key specifications

• Tool type: T-type try square with cross-piece and blade
• Measuring dimensions: 300 x 600 mm reference surface
• Primary use: right-angle measurement and marking
• Material characteristics: rigid construction for minimal flex (material not specified)
• Suitable environments: workshop, construction site, hobby bench

How to use

Place the cross-piece of the T-type try square firmly against the reference edge or face so the blade runs along the surface to be checked or marked. Ensure full contact along the cross-piece to maintain perpendicular alignment, then mark or scribe along the blade for accurate layout lines. For checking squareness, inspect the gap or contact along the blade; rotate the workpiece and repeat to verify consistency. When measuring larger panels, use the blade length as a straight reference and, if necessary, reposition the tool while maintaining alignment to extend the reference.

Usage recommendations

Store the try square on a flat surface or hang by a designated slot to avoid bending the blade. Clean debris from mating surfaces before use to preserve accuracy. For precision work, periodically check squareness against a known standard or calibration square and avoid exposing the tool to extreme temperatures or corrosive environments.