Extension fitting FERRO P110Z brass 3/4" (10 mm) for plumbing connections

FERRO P110Z brass extension fitting 3/4" (10 mm) is designed for plumbing connections in residential and commercial water systems. Manufactured from solid brass, this extension fitting provides mechanical strength and corrosion resistance for extending threaded joints, repairing pipe runs, or connecting fixtures. The compact 3/4" (10 mm) size fits standard threaded plumbing components where a short extension or alignment correction is required.

Advantages

The solid brass construction ensures long-term durability and resistance to corrosion in potable water and general plumbing environments. Its precise machining and threaded ends enable reliable sealing and easy integration into existing threaded pipelines. Compact dimensions allow installation in confined spaces while maintaining mechanical stability and leak-tight performance when used with appropriate sealing materials.

Suitable for

• Extending threaded plumbing joints and pipe connections
• Repairing or replacing short sections of threaded fittings
• Connecting fixtures, valves or adapters in water supply lines
• Use in residential and commercial water distribution systems

Key specifications

• Material: brass (solid)
• Nominal diameter: 3/4" (10 mm)
• Type: extension fitting for threaded connections
• Application: potable water and general plumbing systems
• Finish: machined brass surface

How to use

Prior to installation, ensure mating threads are clean and free of debris. Apply an appropriate thread sealant or PTFE tape to the male threads to ensure a leak-tight joint, following the sealant manufacturer's instructions. Screw the extension fitting into the mating threaded component by hand to start, then tighten with a suitable wrench until secure—avoid excessive torque that could damage threads or deform the fitting. After installation, pressure-test the connection according to system requirements to verify there are no leaks.

Usage recommendations

Use compatible thread sealants approved for potable water systems when installing the fitting. Do not overtighten; tighten to manufacturer-recommended torque ranges for the mating components when available. Inspect fittings periodically for signs of wear or corrosion and replace if damage is detected.