Bar clamp Festool FS-EZ 150/2 15 cm Duraluminium

The Festool FS-EZ 150/2 15 cm Duraluminium bar clamp is a compact, one-handed clamp designed for woodworking and construction tasks that require precise holding and positioning. Made from lightweight duraluminium, the clamp provides a clamping width of up to 150 mm and a spreading range of 120–310 mm. Supplied as a set of two, it supports clamping, overlap clamping and fixing operations and integrates with Festool system accessories such as guide rails and multifunction table (MFT) grooves.

Advantages

The FS-EZ 150/2 combines a tool-free switching function with a pump lever for single-handed operation, enabling rapid changes between clamping and spreading modes. Its lightweight duraluminium construction balances durability with maneuverability, while the integrated release lever allows quick adjustments and controlled release. The clamp’s design includes an attachment for overlap clamping and an interface that fits the side groove of the multifunction table for secure fixing of guide rails and workpieces.

Suitable for

• Woodworking joinery and assembly where precise holding is required
• Fixing guide rails and small workpieces on multifunction tables and mobile workshops
• Clamping tasks that require rapid single-handed operation or positional changes
• Overlap clamping and spreading operations in repair, finishing, and installation work

Key specifications

• Material: duraluminium body for strength and reduced weight
• Clamping width: up to 150 mm
• Spreading range: 120–310 mm
• Operation: one-handed pump lever with integrated release lever
• Modes: tool-free switching between clamping and spreading; overlap clamping capability
• Compatibility: designed to interface with guide rails and side grooves of multifunction tables
• Set contents: two clamps

How to use

Position the clamp so that the fixed jaw sits against the stationary part of the workpiece and the movable jaw is aligned with the part to be secured. Use the hand pump lever to increase clamping pressure until the workpiece is held firmly; the integrated release lever reduces pressure and allows the jaw to be repositioned. To switch between clamping and spreading modes, use the tool-free switching mechanism at the top section; for overlap clamping attach the bottom section accessory and seat the clamp in the MFT side groove when fixing guide rails or small panels. Operate the clamp with one hand to allow simultaneous positioning or alignment with the other hand.

Usage recommendations

Use the FS-EZ 150/2 clamps in pairs for even pressure distribution on longer or wider workpieces. Avoid over-torquing: apply only the pressure needed to hold parts securely to prevent damage to delicate materials. Regularly check and clean the sliding surfaces and release mechanism to maintain smooth single-handed operation and long service life.