Paint and Mortar Mixer GEKO PM-06 80x400 mm SDS-plus (20/40)

GEKO PM-06 80x400 mm SDS-plus (20/40) is a purpose-built paint and mortar mixer designed for use with SDS-plus rotary drills. The mixing paddle measures 80 mm in diameter and 400 mm in length, providing effective circulation of paint, plaster, cement and other building compounds. The SDS-plus shank delivers a secure, quick-fit connection to compatible rotary drills, allowing steady mixing at variable speeds without frequent slippage.

Advantages

The GEKO PM-06 mixer combines a compact diameter with a long shaft to reach deep into buckets and containers while promoting uniform blending. Its SDS-plus connection simplifies attachment and removal, reducing downtime between mixing tasks. The paddle geometry is engineered to break up lumps and minimise air entrainment for consistent, homogenous mixtures suitable for professional and DIY applications.

Suitable for

• Mixing water-based and solvent-based paints
• Preparing plaster, gypsum and joint compounds
• Blending cement, mortar and tile adhesive mixes
• Small to medium batches in construction and renovation work

Key specifications

• Mixing paddle diameter: 80 mm
• Overall length: 400 mm
• Shank type: SDS-plus for mechanical rotary drills
• Designed use: paint, plaster, cement and similar building compounds
• Compatibility: SDS-plus rotary drills with appropriate chuck or adapter

How to use

Insert the SDS-plus shank of the GEKO PM-06 into the compatible drill chuck or holder and ensure it locks securely. Place the paddle into the material container so it reaches near the bottom without touching the base. Start the drill at low speed to avoid splashing, then increase speed gradually until the mixture becomes uniform. Use short mixing intervals and lift slightly while rotating to ensure thorough blending and to prevent over-aeration. After use, run the drill at low speed in clean water to remove residue, then wipe and store the paddle dry.

Usage recommendations

Choose a drill with adequate torque and speed control to match the viscosity of the material being mixed. For dense or heavy mortars, use lower speed and steady pressure. Clean the paddle immediately after use to prevent material hardening and inspect the SDS-plus shank for wear before each use.