Replacement sealing strip for GEKO tile table saw, length 920 mm

Replacement sealing strip for GEKO tile table saw, length 920 mm is a direct-fit sealing component designed for tile cutting tables that require a 920 mm seal. The strip creates a barrier along the cutting area to limit dust and water leakage, helping to keep the work surface cleaner and protect internal components of the tile saw from moisture and abrasive dust. It is offered as an original-equivalent spare part for maintenance and timely replacement.

Advantages

The sealing strip is manufactured to match the dimensions and profile needed for a snug fit on compatible GEKO tile table saws and equivalent models. It reduces water seepage and dust infiltration at the cutting edge, which helps maintain cutting accuracy and reduces cleaning and downtime. The strip is simple to install and replace, enabling quick maintenance without specialized tools. As a dedicated 920 mm length part, it eliminates the need for on-site trimming or adjustments when used on correctly sized tables.

Suitable for

• Replacement of worn or damaged sealing strips on tile table saws with a 920 mm seal channel
• Maintenance and service of GEKO tile cutting tables and equivalent models
• Professional tilers and contractors working with wet cutting setups
• DIY enthusiasts performing periodic upkeep of home tile cutting equipment

Key specifications

• Length: 920 mm
• Function: sealing strip for dust and water containment
• Compatibility: designed for GEKO tile table saws and equivalent models that accept a 920 mm strip
• Material type: flexible sealing material suitable for wet work environments
• Mounting: removable/replaceable profile for straightforward installation

How to use

Turn off and disconnect the tile table saw from power and drain any residual water from the table. Remove the old or damaged sealing strip by loosening any fasteners or sliding it out of its channel, following the machine manufacturer's maintenance guidance. Clean the mounting channel to remove debris and dry the area. Align the replacement 920 mm sealing strip with the channel and press or secure it into place until it sits firmly along the cutting edge. If fasteners are present, refit them to hold the strip securely. Reconnect the saw and test with a small amount of water to verify the seal before resuming full operation.

Usage recommendations

Inspect the sealing strip regularly for cuts, compression or hardening and replace it when wear compromises the seal. Use only compatible 920 mm seals to ensure proper fit and avoid manual trimming that could affect performance. After installation, verify that water and dust containment are adequate during normal cutting tasks and perform routine cleaning to prolong the strip's service life.