Hydraulic two-stage low-profile column jack GEKO 4T - model 5903418302412

Hydraulic two-stage low-profile column jack GEKO 4T is a compact lifting tool designed for raising vehicles and heavy equipment where a reduced collapsed height is required. The two-stage low-profile column provides an extended lifting range while keeping the minimum height small, allowing access under low-clearance vehicles and machinery. The jack combines a hydraulic lifting mechanism with a stable column structure to deliver controlled vertical movement and reliable support during service and repair tasks.

Advantages

This hydraulic two-stage low-profile column jack offers a 4-ton rated lifting capacity and a two-stage telescopic column that maximizes lifting height without increasing the collapsed profile. The hydraulic system enables smooth, controlled lifting with a release mechanism for precise lowering. Its compact footprint and reinforced column design provide stability on workshop floors, while the low collapsed height improves access to vehicles with low ground clearance. The construction is intended for routine garage and workshop use, facilitating safe and repeatable lifting operations.

Suitable for

• Lifting passenger cars and light commercial vehicles with limited ground clearance
• Vehicle maintenance, tire changes and brake work in garages and service bays
• Workshops and fleet service areas that require compact storage and quick deployment
• Positioning and lifting of small industrial machinery for inspection and repair

Key specifications

• Rated lifting capacity: 4 tonnes
• Two-stage low-profile column for extended reach with reduced collapsed height
• Hydraulic lifting mechanism with controlled release for lowering
• Stable column/stand construction suitable for workshop floors
• Compact footprint for easier storage and positioning

How to use

Position the jack on a level, solid surface below the manufacturer's recommended lift points of the vehicle or equipment. Before lifting, ensure the vehicle is in park or gear and the parking brake is engaged; use wheel chocks as required. Place the lifting pad or contact point of the column under the selected lift point, then operate the hydraulic pump to raise the load to the desired height. Once raised, place suitable stands or supports under the vehicle before performing work. To lower, use the control valve to release hydraulic pressure slowly and lower the load in a controlled manner.

Usage recommendations

Use the jack only within its rated capacity and follow all safety practices: inspect the device for damage before each use, avoid side loads, and never work under a vehicle supported solely by the jack—always use properly rated stands. Store the jack in a dry, clean area and perform periodic maintenance of hydraulic components according to workshop procedures.