Rivets set GEKO Geko Zestaw nitów aluminiowych zrywalnych 450 pcs – aluminum blind/pop rivets, 450 pieces

Set of GEKO aluminum blind (pop) rivets, 450 pieces, designed for permanent fastening of thin metal, sheet, plastic or composite panels where access is available from one side. These aluminum rivets provide a lightweight, corrosion-resistant solution for joining materials in repair, metalworking, automotive trim, HVAC and light construction projects. The set contains multiple rivets in sizes suitable for common panel thicknesses and through-holes typically found in workshop and DIY tasks.

Advantages

Aluminum construction ensures corrosion resistance and low weight while maintaining sufficient shear and tensile strength for general fastening tasks. Blind rivet design allows installation from one side, simplifying assembly in tight or obstructed locations. A large 450-piece set reduces the need for frequent reordering and supports a range of small to medium jobs without interruption.

Suitable for

• Joining thin metal sheets and panels
• Attaching plastic or composite panels where access is limited to one side
• Automotive trim repairs and bodywork fastening
• HVAC ductwork and light construction assemblies
• General workshop maintenance and DIY projects

When it may not be suitable

These aluminum blind rivets are intended for light to medium-duty applications and are not appropriate where very high load-bearing capacity or extreme structural strength is required. They may not be suitable for use with highly dissimilar metals where galvanic corrosion is a concern unless appropriate isolation or coatings are used.

Key specifications

• Material: aluminum body and mandrel (rivets designed for non-structural fastening)
• Quantity: 450 pieces in assorted sizes for common panel thicknesses
• Type: blind (pop) rivet for single-side installation
• Typical applications: thin sheet metal, plastics, composites, trim components

How to use

Prepare the parts by aligning panels and drilling a hole matching the rivet diameter. Insert the rivet through the aligned holes so the rivet head sits flush against the outer surface. Use a compatible hand or pneumatic rivet tool to pull the mandrel until the rivet body expands and clamps the materials together; the mandrel will snap off when correct installation tension is reached. Inspect the finished joint for proper flare and grip, and remove any burrs or sharp edges around the hole.

What to consider before purchase

• Match rivet diameter and grip range to material thickness and hole size
• Confirm aluminum is compatible with the metals or materials being joined to avoid galvanic corrosion
• Ensure you have a compatible rivet tool (manual, battery or pneumatic) for efficient installation

Usage recommendations

For consistent results, use clean, correctly sized holes and a rivet tool rated for the rivet diameters in the set. When joining dissimilar metals, apply appropriate isolation or sealant to prevent corrosion. Store the rivets in a dry environment to maintain material condition and ease of handling.