Diamond Cutting Disc GEKO G00261 125 mm Turbo for Stone, Concrete, and Tile (200 pieces unspecified packaging)

Diamond cutting disc GEKO G00261 turbo, 125 mm diameter, is designed for efficient cutting of hard building materials such as natural stone, concrete and ceramic tile. The turbo rim profile combines a serrated cutting edge with segmented gullets to accelerate material removal and reduce friction during cuts. Intended for use with handheld angle grinders, this 125 mm disc provides a balance between cutting speed and edge control for common construction, tiling and masonry tasks.

Advantages

The turbo rim geometry improves debris evacuation and cooling compared with continuous-rim blades, enabling faster penetration into hard materials while maintaining acceptable control. The 125 mm diameter allows work in confined areas and on tiles or masonry elements where larger discs are impractical. The diamond abrasive layer delivers consistent cutting performance on stone, concrete and ceramic surfaces when used with appropriate tools and operating parameters.

Suitable for

• Cutting ceramic and porcelain tiles
• Trimming natural stone and engineered stone
• Cutting concrete blocks, pavers and masonry units
• On-site cutting with handheld angle grinders

Key specifications

• Disc diameter: 125 mm
• Rim type: turbo (segmented/serrated rim profile)
• Primary materials: designed for stone, concrete and ceramic tile
• Intended tool: handheld angle grinder
• Pack quantity indicated: 200 pieces (packaging unspecified)

How to use

Install the disc on a compatible 125 mm angle grinder following the tool manufacturer's mounting and safety instructions. Securely tighten the flange nut and verify the disc rotates free of obstruction before powering on. For best results, mark the cut line and progress steadily without forcing the blade; allow the diamond segments to cut at their designed feed rate. Use water cooling only if the disc specification and the grinder permit wet cutting; otherwise perform dry cutting with intermittent pauses to avoid overheating. Always observe recommended rpm limits and wear appropriate protective equipment including eye, ear and respiratory protection.

Usage recommendations

For prolonged disc life, avoid excessive side pressure and maintain steady linear cuts. When cutting very hard or reinforced concrete, reduce feed speed and make multiple shallow passes rather than a single aggressive cut.